- TEST COMPLETE comes into view. When the test is finished (Ref. Fig. 502/TASK 74-00-00-991-301-A)

- The ENGINE menu comes into view.

 F 『R EEFF : 151-154, E Page 50774-00-00
 E E Aug 01/01 E E ECES E **ON A/C ALL

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 5. Close-up
________ Subtask 74-00-00-860-051
 A. On the panel 50VU:
 (1) Push the ENG/FADEC GND PWR 1(2) pushbutton switch. The ON legend goes off.
 Subtask 74-00-00-862-050
 B. De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
 F 『 EEFF : ALL E Page 50874-00-00
 E E Aug 01/01 ERE
ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 INTENTIONALLY BLANK

 F 『R E E Page 50974-00-00
 E E Feb 01/01 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 INTENTIONALLY BLANK

 F 『R E E Page 51074-00-00
 E E Feb 01/01 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 TASK 74-00-00-710-043- 01 Operational Test of the Ignition System without CFDS
 1. Reason for the Job

__________________
 To do an aural check of the igniter plug operation.

 2. Job Set-up Information

______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the External Power 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure
 3. Job Set-up
__________ Subtask 74-00-00-861-051
 A. Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002). Subtask 74-00-00-860-052
 B. Do the EIS start procedure (upper and lower ECAM display units only) (Ref. TASK 31-60-00-860-001).
 F 『 EEFF : ALL E Page 51174-00-00
 E E Feb 01/00 ERE
ECES E Subtask 74-00-00-865-051

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 C. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU ENGINE/1 AND 2/IGN/SYS A 1JH A03 FOR 1000EM1
 49VU ENGINE/1/FADEC A/AND EIU 1 2KS1 A04 121VU ENGINE/IGN/ENG1/SYS B 3JH1 P41 121VU ENGINE/IGN/ENG1/SYS A BAT 2JH1 P39 121VU ENGINE/ENG1/FADEC B/AND EIU 1 4KS1 R41
 FOR 1000EM2
 49VU ENGINE/2/FADEC A/AND EIU 2 2KS2 A05 121VU ENGINE/IGN/ENG2/SYS B 3JH2 P42 121VU ENGINE/IGN/ENG2/SYS A BAT 2JH2 P40 121VU ENGINE/ENG2/FADEC B 4KS2 Q40
 Subtask 74-00-00-860-053
 D. Aircraft Maintenance Configuration
 (1) On the MAINTENANCE PNL 50VU:

 (a) Release the ENG / FADEC GND PWR / 1(2) pushbutton switch. The ON legend of this pushbutton switch comes on.

 (2) On the ENG PNL 115VU, make sure that:

 (a) The ENG/MODE/CRANK/NORM/IGN START selector switch is set to NORM.

 (b) The ENG/MASTER 1(2) control switch is set to OFF.

 (3) On the OVERHEAD CTL & IND PNL 22VU:

 - Make sure that the ON legend of the ENG/MAN START/1(2) pushbutton switch is off (the pushbutton switch is released out).

 (4) On the HYD/FUEL PNL 40VU:

 (a) Make sure that the OFF legends of all the FUEL/PUMPS pushbutton switches are on (the pushbutton switches are released out).
 F 『 EEFF : ALL E Page 51274-00-00
 E E Feb 01/00 ERE
ECES E 4. Procedure

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

_________ Subtask 74-00-00-710-051
 A. Test
 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the ENG PNL 115VU:
- Set the ENG/MODE/CRANK/NORM/IGN START selector switch to IGN START.
2. On the OVERHEAD CTL & IND CTL 22VU:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM IGNITION 點火(6)