(2) Close the fan cowl doors: (Ref. TASK 71-13-00-410-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 (3) Remove the warning notice(s).

 F 『 EEFF : ALL E Page 40779-21-30
 E E Nov 01/02 ERE
ECES E

 F  『
 E  C F M  E
 E  E

 E 56-5B E
 E E

 TASK 79-21-30-000-002
 Removal of the DPM Harness
 1. Reason for the Job

__________________
 Self Explanatory

 2. Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific blanking caps
 No specific blanking plugs
 No specific soft-nose connector pliers
 No specific warning notice

 B. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors R 79-21-30-991-302 Fig. 403
 3. Job Set-up
__________
 Subtask 79-21-30-941-052

 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
 F 『 EEFF : ALL E Page 40879-21-30
 E E Nov 01/02 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).
 Subtask 79-21-30-010-052
 B. Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 4. Procedure
_________
R (Ref. Fig. 403/TASK 79-21-30-991-302)
 Subtask 79-21-30-020-051
 A. Removal of the DPM harness
 (1) Disconnect the DPM harness from the visual indicator.
 NOTE : Disconnect the magnetic chip detector harness from the DPM
____ harness receptacle (150). Use soft-nose connector pliers only if necessary.
 (2) Remove the DPM harness as follows:
 -------------------------------------------------------------------------------REMOVE FROM NOTE -------------------------------------------------------------------------------lockwire nut (140) DPM harness receptacle (150) bracket (160) (detail G)
 DPM harness  clips (100) and (120) at the 8 o'clock on brackets (110) and position on flanges
 (130)  C and D (detail E and F)
 bolt (70) at the 8 o'clock clamp (80) brackets (90) position on flange D (detail D)
 bolt (40) at the 8:30 o'clock clamp (50) brackets (60) position on flange D (detail C)
 F 『 EEFF : ALL E Page 40979-21-30
 E E Nov 01/02 E E ECES E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E -------------------------------------------------------------------------------REMOVE FROM NOTE -------------------------------------------------------------------------------

R  Removal/Installation of the DPM Harness Figure 403/TASK 79-21-30-991-302- 13 (SHEET 1)
 F EEFF : E E ECES  ALL  『E 79-21-30EEE Page 410 Nov 01/02

R  Removal/Installation of the DPM Harness Figure 403/TASK 79-21-30-991-302- 23 (SHEET 2)
 F EEFF : E E ECES  ALL  『E 79-21-30EEE Page 411 Nov 01/02

R  Removal/Installation of the DPM Harness Figure 403/TASK 79-21-30-991-302- 33 (SHEET 3)
 F EEFF : E E ECES  ALL  『E 79-21-30EEE Page 412 Nov 01/02

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

bolt (10) at the 9 o'clock clamp (20) brackets (30) position on flange
 (3) Put blanking caps and blanking plugs on the connectors and the receptacles.
 F 『 EEFF : ALL E Page 41379-21-30
 E E Nov 01/02 ERE
ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM OIL 滑油(52)