.. the pin A/A2 of the RTL SYS 1 relay (13CC1)
.. the pin A/A2 of the RUD TRIM 1 relay (7CC1)
. the pin A/A1 of the RTL SYS 1 relay (13CC1) and the pin A/A of the
RUDDER TRAVEL limitation unit (4CC)
. the pin A/A1 of the RUD TRIM 1 relay (7CC1) and the pin B/T of the
RUDDER TRIM actuator (10CC)
(Ref. ASM 22-67/01).
(1) If the wiring is not correct:
- repair it.
(2) If the wiring is correct:
- replace the RTL SYS 1 - RELAY (13CC1) and the RUD TRIM 1 - RELAY (7CC1)
(3) If the fault continues:
- replace the ACTUATOR-RUDDER TRIM (10CC) (Ref. AMM TASK 27-22-51-000-001) and (Ref. AMM TASK 27-22-51-400-001).
(4) If the fault continues:
- replace the LIMITATION UNIT-RUDDER TRAVEL (4CC) (Ref. AMM TASK 27-23-51-000-001) and (Ref. AMM TASK 27-23-51-400-001).
(5) If the fault continues:
- replace the FAC-1 (1CC1) (Ref. AMM TASK 22-66-34-000-002) and (Ref. AMM TASK 22-66-34-400-002).
(6) If the fault continues:
- do a check of the integrity of the SERVO ACTR-YAW DAMPER, 1 (3CC1) and FAC-1 (1CC1) by the following trouble shooting procedure (Ref. TASK 22-63-00-810-801).
NOTE : Disregard the maintenance message.
____
C. Do the Operational Test of the AFS (Ref. AMM TASK 22-96-00-710-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞22-66-00∞∞∞∞∞∞∞∞∞∞Page A224
May 01/04R
CES Loss of FAC 2 after 28VDC FAC 2 circuit breaker tripping
1. Possible Causes
_______________
- ACTUATOR-RUDDER TRIM (10CC)
- LIMITATION UNIT-RUDDER TRAVEL (4CC)
- FAC-2 (1CC2)
- SERVO ACTR-YAW DAMPER, 2 (3CC2)
- 28VDC FAC2 Power Supply wiring
- RTL SYS 2 - RELAY (13CC2)
- RUD TRIM 2 - RELAY (7CC2)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION
-------------------------------------------------------------------------------
22-63-00-810-802 Loss of the Yaw Damper Function on the FAC 2
AMM 22-66-34-000-002 Removal of the FAC (1CC1,1CC2)
AMM 22-66-34-400-002 Installation of the FAC (1CC1,1CC2)
AMM 22-96-00-710-001 Operational Test of the AFS
AMM 27-22-51-000-001 Removal of the Rudder Trim Actuator (10CC)
AMM 27-22-51-400-001 Installation of the Rudder Trim Actuator (10CC)
AMM 27-23-51-000-001 Removal of the Rudder Travel Limitation Unit 4CC
R AMM 27-23-51-400-001 Installation of the Rudder Travel-Limitation Unit 4CC ASM 22-67/01
3. Fault Confirmation
__________________
A. Not applicable.
4. Fault Isolation
_______________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU AUTO FLT/FAC2/28VDC 5CC2 M19
B. If the fault symptom is identified by the trip of the 28VDC FAC2 circuit breaker:
- do a check for short circuit of the 28VDC FAC2 Power Supply wiring between: . the pin 2 of the AUTO FLT/FAC2 circuit breaker (5CC2) and respectively: .. the pin AC/2 of the FAC2 (1CC2)
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞22-66-00∞∞∞∞∞∞∞∞∞∞Page A225
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 AUTO FLIGHT 自動飛行2(41)
