- THE FLIGHT CONTROLS
- THE FLIGHT CONTROL SURFACES
- THE LANDING GEAR AND THE RELATED DOORS
- COMPONENTS THAT MOVE.
1. Possible Causes
_______________
R - UPLOCK ASSY-NLG (2530GM)
- UPLOCK ASSY-NLG DOOR (2534GM)
- SAFETY VALVE-L/G SYS ISOLATION (49GA)
- ACTG CYL-NLG (2527GM) R - proximity sensors and targets R - grease contamination of the uplock proximity sensors and targets
- NLG hinge bearing clearances R
- NLG Door Fully Open proximity sensors
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
32-31-00-810-818 NLG Door Open Proximity Sensor Fault (36GA, 37GA,
38GA, 39GA) R 32-31-00-810-846 L/G Failure of one of the uplock proximity sensors R 8GA thru 13GA
AMM 32-21-00-200-004 Inspection/Check of the Clearance of the Nose-Gear
Hinge Bearings AMM 32-21-00-200-005 Detailed Inspection/Check of the NLG AMM 32-31-00-200-001 Detailed Inspection of Gear Uplock and Door Uplock
Units and Pins AMM 32-31-00-710-005 Operational Check to Ensure Safety Valve Closes at 260 kts AMM 32-31-00-720-003 Functional Test of the Normal Extension and
Retraction of the Nose Landing Gear AMM 32-31-14-000-001 Removal of the NLG Door Uplock Assy (2534GM) AMM 32-31-14-200-001 Detailed Visual Inspection of the Nose Landing-Gear
Door-Uplock AMM 32-31-14-400-001 Installation of the NLG Door Uplock Assy (2534GM) AMM 32-31-17-000-001 Removal of the Landing Gear Safety-Valve
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞32-31-00∞∞∞∞∞∞∞∞∞∞Page A242
Aug 01/05 CES -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R AMM 32-31-17-400-001 Installation of the Landing Gear Safety-Valve AMM 32-31-22-000-001 Removal of the NLG Actuating Cylinder (2527GM) AMM 32-31-22-400-001 Installation of the NLG Actuating Cylinder (2527GM)
R
3. Fault Confirmation
__________________
A. Procedure
(1) Do a check of the post flight report:
- if there is a SYS DISAGREE ECAM message and related NLG uplock target-position CFDS message, do the fault isolation procedure from Para 4.A.(1)
- if there is no ECAM or CFDS message, but a loud noise was heard below the cockpit, do the fault isolation procedure from Para. 4.A.(8)
- if there is no ECAM or CFDS message, but the NLG door opens and closes undemanded, do the fault isolation procedure from Para. 4.A.(11).
4. Fault Isolation
_______________
A. Procedure
NOTE : The procedure that follows, gives the information necessary to
____ identify mechanical faults related to the NLG and the NLG doors.
(1) Do the detailed inspection/check of the nose landing gear (Ref. AMM TASK 32-21-00-200-005).
R (2) Do a check of the UPLOCK ASSY-NLG (2530GM) proximity sensors and R targets (Ref. TASK 32-31-00-810-846).
R (a) If the indications are not correct during the check, do the R following:
R 1_ Do a check for grease contamination of the uplock proximityR sensors and targets.
R 2_ If there is too much grease in the area, clean off the greaseR and do the check in Para. 4.A. again.
R NOTE : Grease contamination can cause incorrect indications.
____
(3) Do the inspection/check of the NLG hinge bearing clearances (Ref. AMM TASK 32-21-00-200-004).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞32-31-00∞∞∞∞∞∞∞∞∞∞Page A243
Aug 01/05 CES
R (4) Do The Detailed Visual Inspection of the NLG Uplock (Ref. AMM TASK 32-31-00-200-001).
(5) If a fault is found, do the applicable repair.
(6) Do the functional test of the normal extension and retraction of the nose landing gear (Ref. AMM TASK 32-31-00-720-003).
R R (7) If the fault continues, do a check of the NLG Door Fully Open proximity sensors (Ref. TASK 32-31-00-810-818)
R R (8) If the fault continues, Do the Detailed Visual Inspection of the NLG Door Uplock (Ref. AMM TASK 32-31-14-200-001).
R R (9) Do the Functional Test of the Normal Extension and Retraction of the Nose Landing Gear (Ref. AMM TASK 32-31-00-720-003).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 起落架 LANDING GEAR 1(56)
