『E
∞∞80-00-00∞∞∞∞∞∞∞∞∞∞Page 204
E May 01/99EE 3. Fault Confirmation
F 『
E C F M E
E E
E 56 E
E E
__________________
A. Test
(1) Do the operational test of the FADEC on the ground (with engine non motoring) (Ref. AMM TASK 73-29-00-710-040).
4. Fault Isolation
_______________
A. If the test does not give a maintenance message:
- do an operational test of the ignition system to do an aural check of the spark igniter operation (Ref. AMM TASK 74-00-00-710-043).
(1) If the spark igniter operates correctly:
- replace the ECU (4000KS) (Ref. AMM TASK 73-21-60-000-001) and (Ref. AMM TASK 73-21-60-400-001).
(2) If the spark igniter does not operate correctly:
- do a check for open or short to ground of the J1 wiring between the ECU (4000KS) and the upper ignition exciter (Ref. ASM 74-31/01)
- do a check for open or short to ground of the J2 wiring between the ECU(4000KS) and the lower ignition exciter (Ref. ASM 74-31/01).
(a) If the wiring is not correct:
- repair the above wiring.
(b) If the wiring is correct:
- replace the right spark igniter or
- replace the left spark igniter or (Ref. AMM TASK 74-21-30-000-002) and (Ref. AMM TASK 74-21-30-400-002).
1_ If the fault continues:
- replace the right ignition lead or
- replace the left ignition lead (Ref. AMM TASK 74-21-10-000-
002) and (Ref. AMM TASK 74-21-10-400-002) or (Ref. AMM TASK
74-21-20-000-002) and (Ref. AMM TASK 74-21-20-400-002).
a If the fault continues:
_
- replace the lower ignition exciter
- replace the upper ignition exciter (Ref. AMM TASK 74-11-10-000-002) and (Ref. AMM TASK 74-11-10-400-002).
b If the fault continues:
_
- make sure that there is no ground signal at the EIU2 (1KS2) pin AA/5B (Ref. ASM 74-31/01).
c If the fault continues:
_
- replace the EIU-2 (1KS2) (Ref. AMM TASK 73-25-34-000-040) and (Ref. AMM TASK 73-25-34-400-040).
F 『 EEFF : ALL E ∞∞80-00-00∞∞∞∞∞∞∞∞∞∞Page 205
E E Feb 01/98 E E ECES
E F 『 E C F M E E E E 56 E E E d If the fault continues:
_
- replace the ECU (4000KS) (Ref. AMM TASK 73-21-60-000-001) and (Ref. AMM TASK 73-21-60-400-001).
B. Do an engine automatic start procedure indication (Ref. AMM TASK 71-00-00-710-003) .
F 『 EEFF : ALL E ∞∞80-00-00∞∞∞∞∞∞∞∞∞∞Page 206
E E Feb 01/98 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
TASK 80-00-00-810-831
Operation Time for the Starter More Than the Limits, on Engine 1 or 2
1. Possible Causes
_______________
- pneumatic starter
- ECU (4000KS)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 71-00-00-710-003 Engine Automatic Start
R AMM 73-21-60-000-001 Removal of the Electronic Control Unit (ECU)(4000KS) AMM 73-21-60-400-001 Installation of the Electronic Control Unit
R (ECU)(4000KS) AMM 73-29-00-710-040 Operational Test of the FADEC on the Ground (with Engine non Motoring) AMM 80-11-10-000-002 Removal of the Pneumatic Starter AMM 80-11-10-400-002 Installation of the Pneumatic Starter
3. Fault Confirmation
__________________
A. Test
(1) Do the operational test of the FADEC on the ground (wirh engine non motoring) (Ref. AMM TASK 73-29-00-710-040). 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 STARTING 起動(4)
