(3)  
Open all fuel system and indicator light circuit breakers on P6 panel.

(4)  
Remove external electrical power, if no longer required.

515 
Oct 20/84  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  28-22-81 Page 413 

APU FUEL FEED LINE - INSPECTION/CHECK
1.  General
A.  This procedure has one task:
(1)  Do a check of the APU fuel feed line for leakage.
B.  If the leakage rate from the APU fuel feed line is more than the limits, the APU fuel feed line must be replaced or the APU fuel feed line must be drained and the APU must be deactivated as inoperative until the APU fuel feed line can be replaced.
C.  The APU fuel feed line shroud is referred to as the APU shroud.
2.  APU Fuel Feed Line Leakage Check
A.  Equipment
(1)  
Container - applicable for fuel

(2)  
Collar - Circuit Breaker

B.  APU Fuel Feed Line Leakage
(1)
Put a container under the drain mast to catch the fuel from the APU shroud.

NOTE: The drain mast is located outboard and aft of the left main gear wheel well.

(2)  
Do a check of the drain leakage rate at the drain mast.

(a)  
Measure the fuel leakage rate at the drain mast for 5 minutes.

(b)  
If the fuel leakage rate is not more than 1 drop per minute, the fuel leakage rate is OK.

(c)  
If the fuel leakage rate is more than 1 drop per minute, do the In-Service Operational Check.

C.  In-Service Operational Check
(1)  Pressurize the APU fuel line to do a check for leakage.
(a)  
Put a container under the drain mast to catch all the fuel from the APU shroud.

(b)  
Connect the external electrical power to the airplane (AMM 28-22-00/201).

(c)  
Make sure these circuit breakers are closed:

1)  On the main power distribution panel, P6: a) BOOST PUMP FWD TANK 2 b) SHUTOFF VALVE ENG 1 c) SHUTOFF VALVE ENG 2 d) APU CONT e) CROSSFEED VALVE f) IND LT

(d)  
Make sure the engine start levers on the engine control stand are at the CUTOFF position to close the two engine shutoff valves.

(e)  
Set the fuel crossfeed valve switch on the P5 overhead panel to the OPEN position.

(f)  
Open the APU fuel valve. 1) Set the BATTERY switch on the P5 overhead panel to ON. 2) Set the APU master switch on the P5 overhead panel to ON.

(g)  
Set the No. 2 tank, FWD boost pump switch, on the P5 overhead panel, to the ON position. 1) To operate any of the fuel boost pumps, you must be in the flight compartment

500 
May 01/03  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  28-22-81 Page 601 

to continuously monitor the fuel quantity and the low pressure indication in the fuel tank.
WARNING:  DO NOT OPERATE ANY FUEL BOOST PUMP IF THE LOW PRESSURE LIGHT COMES ON AND STAYS ON. FUEL VAPORS IN THE TANK MAY IGNITE AND CAUSE A FIRE OR EXPLOSION.
a)  Immediately put the applicable fuel boost pump switch(es) to OFF if the LOW PRESSURE light comes on and stays on.
NOTE:  When defueling or transferring fuel with minimum backpressure to the pumps, it is possible for the low pressure light(s) to be on.  In this case, monitor the tank quantity and put the pump switch(es) to OFF if the tank quantity is not changing.
(h)  
Keep the pressure on the APU fuel feed line for 30 minutes.

(i)  
Set the No. 2 tank FWD boost pump switch to the OFF position.

(j)  
Close the APU fuel valve.
1) Set the APU master switch to OFF.
2) Set the BATTERY switch to OFF.

(2)  
Measure the quantity of fuel in the container: this is the fuel leakage from the drain mast collected over 30 minutes.

(3)  
If the quantity of fuel is not more than 60 drops (3 milliliters) in 30 minutes, do these steps:

(a)  
Continue to operate the APU.

(b)  
Do the In-Service Operational Check daily until you can repair the leak or replace the APU fuel feed line (AMM 28-22-81/401).

(4)  
If the quantity of fuel is more than 60 drops (3 milliliters) in 30 minutes, do the applicable steps:

(a)  
Replace the APU fuel feed line (AMM 28-22-81/401) or

(b)  
Do these steps to deactivate the APU and fully drain the APU fuel feed line: 1) Make sure the APU master switch is at the OFF position and install a APU INOPERATIVE tag.

2)  Open and collar this circuit breaker on the P6 Main Power Distribution Panel, to deactivate the APU fuel shutoff valve in the closed position: a) APU CONT
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機(jī)維護(hù)手冊(cè) 燃油 FUEL(137)