TABLE II EXTERIOR EMERGENCY LIGHTS
EXTERIOR EMER LIGHT RIGHT SIDE LEFT SIDE
DOOR #1 SLIDE LIGHT 1 Light 1 Light
EMER EXIT SLIDE LIGHT 2 Lights 2 Lights
DOOR #2 SLIDE LIGHT 1 Light 1 Light
2. Emergency Lights Operational Test
A. Apply electrical power (Ref 24-22-0, MP).
B. Verify EMER EXIT LIGHTS switch on P5 overhead panel is in OFF.
C. Verify EMER EXIT switch on P14 aft attendants' panel is guarded in NORM.
D. Verify emergency light batteries have been charged at least 16 hours prior to test.
E. Verify that EMER EXIT LIGHTS circuit breaker on P18-3 circuit breaker panel is closed.
Oct 20/84 33-51-02 Page 501
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
3. Emergency Lights System Test
A. Apply electrical power (Ref 24-22-0, MP).
B. Lift guard of EMER EXIT switch on P14 aft attendants' panel and position switch to ON.
CAUTION: RETURN SWITCH TO OFF POSITION AS SOON AS POSSIBLE TO
CONSERVE BATTERIES.
C. Verify lights in Tables I and II are on.
D. Position EMER EXIT switch on P14 aft attendants' panel to NORM.
E. Verify lights in Tables I and II are off.
F. Place EMER EXIT LIGHTS switch on P5 overhead panel to ARMED.
G. Position EMER EXIT switch on P14 aft attendants' panel to ON.
CAUTION: RETURN SWITCH TO OFF POSITION AS SOON AS POSSIBLE TO
CONSERVE BATTERIES.
H. Verify lights in TABLES I and II are on.
I. Position EMER EXIT switch on P14 aft attendants' panel to NORM and lower guard over it.
J. Verify lights in TABLES I and II are off.
K. Place EMER EXIT LIGHTS switch on P5 overhead panel to ON.
CAUTION: RETURN SWITCH TO OFF POSITION AS SOON AS POSSIBLE TO
CONSERVE BATTERIES.
L. Verify lights in Table I, II, and NOT ARMED light are on and MASTER CAUTION lights and OVERHEAD right system Master Caution annunciator are illuminated.
M. Place EMER EXIT LIGHTS switch on P5 overhead panel to OFF.
N. Verify lights in Table I and II are off, the NOT ARMED light is on, and Master Caution lights and OVERHEAD right system Master Caution annunciator are illuminated.
O. Place EMER EXIT LIGHTS switch on P5 overhead panel to ARMED.
CAUTION: RETURN SWITCH TO OFF AS SOON AS POSSIBLE TO CONSERVE
BATTERIES.
P. Depress MASTER CAUTION light.
Q. Verify lights in Table I, II, and NOT ARMED light are off and Master Caution lights and OVERHEAD right system master caution annunciator are off.
R. Open circuit breaker EMER EXIT LTS on P18-3 circuit breaker panel.
S. Verify lights in Tables I and II are on.
T. Place EMER EXIT LIGHTS switch on P5 overhead panel to OFF.
U. Verify lights in Table I, II, and NOT ARMED light are out.
V. Close circuit breaker EMER EXIT LTS on P18-3 circuit breaker panel.
CAUTION: DO NOT LEAVE EMERGENCY LIGHTS OPERATING AFTER COMPLETION OF TESTS. PRIOR TO REMOVING POWER FROM AIRPLANE, CHECK THAT POSITION OF EMER EXIT LIGHTS SWITCH ON THE FORWARD OVERHEAD PANEL IS OFF AND ALL EMERGENCY LIGHTS ARE OUT.
W. Remove electrical power if no longer required (Ref 24-22-0, MP).
5C9
33-51-02 Page 502 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. Feb 20/84
EXIT AND EMERGENCY LIGHTS - ADJUSTMENT/TEST
EFFECTIVITY
ALL EXCEPT ATI INTERIOR
1. General
A. The emergency lights system batteries should be fully charged prior to testing. If batteries are discharged, provide electrical power for at least 16 hours prior to testing.
2. Exit and Emergency Lights Test
A. Prepare to Test Exit and Emergency Lights
(1)
Provide electrical power (Ref 24-22-0, MP).
(2)
Check that EMERGENCY EXIT PWR and EMERGENCY EXIT CONT circuit breakers on panel P18 are closed.
(3)
Check that two MASTER CAUTION BUS, DIM AND TEST, and nine INDICATOR MASTER DIM BUS circuit breakers on panel P6 are closed.
B. Test Exit and Emergency Lights
(1)
With EMER EXIT LIGHTS switch on forward overhead panel in OFF position, and EMER EXIT switch (if installed) on aft attendant's panel in NORM position, check that the following conditions exist:
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機維護手冊 燈 LIGHTS(64)
