C.  Roll and Pitch Servo Test
(1)  
Place VERTICAL GYRO transfer switch in NORMAL position. Check that both ADI's indicate 0.0 士 2 degrees roll and pitch attitude 1 minute after power is applied.

(2)  
Tilt vertical gyro No. 1 until captain's ADI indicates 10 degrees pitch down (attitude assembly moves toward top of indicator). Check that tilt table indicates 10 士 2 degrees pitch down.

NOTE:  ADI should follow displacements of vertical gyro smoothly with no sluggishness or overshoot.

(3)  
Tilt vertical gyro No. 1 until captain's ADI indicates 10 degrees pitch up. Check that tilt table indicates 10 士 2 degrees pitch up.

(4)  
Tilt vertical gyro No. 1 until captain's ADI indicates 20 degrees right roll (attitude assembly rotates counterclockwise). Check that tilt table indicates 20 士 3 degrees right roll.

(5)  
Tilt vertical gyro No. 1 until captain's ADI indicates 20 degrees left roll. Check that tilt table indicates 20 士 3 degrees left roll.

(6)  
Repeat steps (3) thru (6) using vertical gyro No. 2 and first officer's ADI.

(7)  
Place VERTICAL GYRO transfer switch in CAPT ON AUX position and repeat steps (3) thru (6) using auxiliary gyro and captain's ADI.

(8)  
Place VERTICAL GYRO transfer switch in F/O on AUX position and repeat steps (3) thru

(6) using auxiliary gyro and F/O's ADI.

(9)  
Return vertical gyros to level attitude.

D.  Restore Airplane to Normal
(1)  
Open all attitude reference system circuit breakers.

(2)  
Allow 3 minutes for gyros to run down; install in airplane and connect electrical cables.

(3)  
Close system circuit breakers and verify that system indicates attitude of airplane.

(4)  
Determine whether there is further need for electrical power, if not, remove power.

505 
34-22-02 Page 504  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  Oct 20/84 

VERTICAL GYRO -REMOVAL/INSTALLATION
1. General
A.  A gyro should not be removed from its seating position until its rotor has come to rest. At least 3 minutes should be allowed after switch off, in order to meet this requirement.
B.  Particular care should be exercised in transporting a gyro from place to place. It is a delicate instrument which will not withstand knocks or rough handling. Use approved containers for transportation whenever possible.
C.  Where necessary, laminated shim stock is used to seat each gyro within required tolerances relative to the airplane's axes. Prior to incorporation of SB 34-1171, (on airplanes with shims bonded to the mounting brackets), extreme care should be exercised when removing the gyros to ensure that the shims are not dislodged; and, if they are, to return them to their original positions when replacing the gyro. After incorporation of SB 34-1171, the shims are riveted to the mounting brackets.
2.  Remove Vertical Gyro
A.  Remove power from the attitude system.
B.  Remove three screws attaching gyro to mounting plate (Fig. 401).
C.  Bag screws and attach to gyro or mounting.
D.  Disconnect electrical connector from gyro to be removed. (Move gyro as necessary to gain access to electrical connectors.)
E.  Remove gyro.

3.  Install Vertical Gyro
A.  Place vertical gyro on mounting plate as shown in Fig. 401. Arrow on top of unit should be pointing forward.
B.  Connect electrical connector; tighten and lockwire.
C.  Align holes in mounting surfaces and install three mounting screws. Tighten screws.
5B3 
Oct 20/85  B
O
E
I
NG P
R
OP
RI
E
T
A
R
Y
 - Copyri
ght
 . - Unpubl
i
s
hed W
o
rk
 - S
ee t
i
t
l
e page f
o
r det
ai
l
s
.
 34-22-11 Page 401 

K77989
Vertical Gyro Installation  5C8 
34-22-11  Figure 401  Jun 20/86 
Page 402 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 

D.  Connect external electrical power or use APU power.
E.  Check that all vertical gyro, F/O's ADI and CAPT's ADI circuit breakers are closed.
F.  Place VERTICAL GYRO switch in NORMAL position.
G.  Allow 1 minute for gyros to stabilize and check that ADI's indicate airplane attitude and that GYRO flags are out of view.
H.  Disconnect electrical power.
551 
May 01/75  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  34-22-11 Page 403 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機(jī)維護(hù)手冊 導(dǎo)航 NAVIGATION 1(82)