曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 D.  Lifting a damaged airplane is covered in Airplane Recovery Document D6-40146.
 E.  When necessary to obtain additional tail clearance for positioning an airplane in a hangar or storage area, a nose lift dolly may be used to tilt the airplane. The nose lift dolly raises the airplane nose section, causing the airplane to tilt at the main gear.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 07-10-00
 ALL  ú ú 01 Page 1 ú Mar 15/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 LIFTING AIRPLANE FOR MAINTENANCE - DESCRIPTION AND OPERATION
____________________________________________________________
 1.  General_______
 A.  Lifting the airplane for maintenance is accomplished by using conventional airplane jacks at jack points located on the wing, forward and aft body or at the nose and main landing gear. You can remove and install jack adapters at the wing and body jack points. The nose and main landing gear jack points are integral with the landing gear.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 07-11-00
 ALL  ú ú 01 Page 1 ú Mar 15/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 JACK AIRPLANE - MAINTENANCE PRACTICES
_____________________________________
 1.  General_______
 A.  The airplane has three main jack points and four auxiliary jack points. The main jack points are the wing jack points A and B and aft body jack point C. The four auxiliary jack points contain one stabilizing and three landing gear jack points. The stabilizing jack point is the forward body jack point D. The three landing gear jack points are points F at each main gear axle and point E below the nose gear axle. See Fig. 201 and 202 for the jack point locations, maximum loads on the jack points, and wing and body jack adapters.
 B.  You can lift the airplane on jacks at different gross weights as long as the load on the individual jack points is not more than the maximum permitted. Also, the sum of the individual jack point loads must not be more than the maximum jack weight (Fig. 202). At all weights, the airplane center of gravity must be to the C.G. range of 5 to 31 percent MAC before you lift it on jacks.
 C.  The design of the axle jack points will permit you to change two flat tires on the same landing gear while the airplane is at the maximum taxi weight. The load on an axle jack point must not be more than the maximum permitted.
 TASK 07-11-11-842-001
 2.  Prepare to Lift the Airplane On Jacks_____________________________________
 A.  Equipment
 (1)  
F80016 - Main Landing Gear Oleo Lock Assembly

 (2)  
F80234-1 - Main Landing Gear Oleo Lock Assembly (Alternative)

 (3)  
6ME65-73762 - Nose Landing Gear Shock Strut Retainer

 (4)  
F70263-1 - Nose Landing Gear Shock Strut Retainer (Alternative)

 (5)  
Wing and Fuselage Jacks, Axle Jacks, and Jack Pad Adapters (Fig. 202)

 (a)  
50-60-44 - Wing Jacks - Regent Model (or equivalent)

 (b)  
F80060-6 - Wing Jack Pad Adapter

 (c)  
15-54-40 - Forward Body Jack - Regent Model (or equivalent)

 (d)  
F80000-7 - Forward Body Jack Pad Adapter

 

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 07-11-11
 ALL  ú ú 02 Page 201 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL

A E
Jack Point Locations
Figure 201

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 07-11-11
 ALL  ú ú 01 Page 202 ú Nov 15/92
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 LIFTING AND SHORING(2)