S 014-004-C00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 74-11-01
 ALL  ú ú C01 Page 401 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
IGNITION 
EXCITER 
SEE  A 
BOND 
JUMPER 
LEFT LEAD IGNITION  EXCITER UPPER IGNITION 

ELECTRICAL INPUT CONNECTOR
IGNITION LEAD POWER SUPPLY
CONNECTOR CABLE
RIGHT
IGNITION
LEAD

IGNITION EXCITER MOUNTING NUT AND WASHER (8 LOCATIONS) ELECTRICAL INPUT CONNECTOR
IGNITION LEAD
CONNECTOR

POWER SUPPLY CABLE
BOND
JUMPER

LOWER IGNITION
EXCITER

A
G-M56-MM-0174(1)-00-B
Ignition Exciter Installation Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 74-11-01
 ALL  ú ú C01 Page 402 ú Jul 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 034-014-C00
 WARNING:_______THE IGNITION SYSTEM VOLTAGE IS DANGEROUSLY HIGH. DO NOT TOUCH THE IGNITION COMPONENTS UNTIL YOU DO THE PROCEDURE THAT FOLLOWS. THIS PROCEDURE WILL RELEASE THE HIGH VOLTAGE FROM THE IGNITION EXCITER. IF YOU DO NOT OBEY THIS PROCEDURE, INJURY TO PERSONS CAN OCCUR.
 (4)  Do these steps to release the high voltage from the ignition exciter:
 (a)  
Set the start switch to the OFF position.

 (b)  
Stop (wait) for a minimum of 2 minutes.

 S 034-015-C00
 (5)  Do these steps to remove the exciter:
 (a)  
Disconnect the connector on the forward side of the exciter.

 (b)  
Disconnect the cable on the forward side of the exciter.

 (c)  
Disconnect the connector on the aft side of the exciter.

 (d)  
Put dust caps on the open connectors.

 (e)  
Hold the stud, with the open end of the wrench on the stud flat, between the mount and the exciter.

 (f)  
Remove the nuts and washers that attach the exciter to the bracket (4 locations).

 S 024-005-C00
 (6)  Remove the exciter from the studs.
 NOTE: The bond jumper must stay attached to the fan case.
____
 TASK 74-11-01-404-006-C00
 3.  Install the Ignition Exciter____________________________
 A. Consumable Materials
 (1)  Graphite Grease - CP 2101
 B. References
 (1)  
AMM 70-10-01/201, Consumable Materials

 (2)  
AMM 71-11-02/201, Fan Cowl Panels

 (3)  
AMM 74-00-00/501, Ignition

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 74-11-01
 ALL  ú ú C01 Page 403 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
C. Access
 (1)  
Location Zones
 101 Control Cabin - Left
 102 Control Cabin - Right
 502/503 Fan Cowl Panels - Engine No. 1
 602/603 Fan Cowl Panels - Engine No. 2
 506 Engine No. 1
 606 Engine No. 2

 (2)  
Access Panels
 5737L Engine No. 1 - Right Fan Cowl Panel
 5746L Engine No. 1 - Left Fan Cowl Panel
 5837R Engine No. 2 - Right Fan Cowl Panel
 5846R Engine No. 2 - Left Fan Cowl Panel

 D. Install the Exciter
 S 214-007-C00
 (1)  If the left (upper) exciter is to be removed, make sure this circuit breaker is open and DO-NOT CLOSE tag is attached:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 點火 IGNITION(7)