S 214-008-C00
 (2)  If the right (lower) exciter is to be removed, make sure this circuit breaker is open and DO-NOT-CLOSE tag is attached:
 (a)  P6 Load Control Center
 1) R IGN

 S 644-017-C00
 (3)  
Lightly apply graphite grease (CP 2101) to the threads and pressure faces of four mounting bracket studs (AMM 70-10-01/201).

 S 424-016-C00

 (4)  
Do these steps to install the exciter:

 (a)  
Install the exciter on the bracket studs.

 (b)  
Hold the stud, with the open end of the wrench on the stud flat, between the mount and the exciter. 1) Install the exciter with four nuts and washers. 2) For the upper exciter, connect the bond jumper to the upper

 left stud.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 74-11-01
 ALL  ú ú C01 Page 404 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
3)  For the lower exciter, connect the bond jumper to the lower left stud.
 NOTE: Make sure the bond jumper is between the washer and
____
 the exciter.

 4)  Tighten the nut to 55-70 pound-inches (6-8 Newton meters).
 (c)  Connect the ignition lead to the connector on the aft side of the exciter. 1) Tighten the connector nut to 140-160 pound-inches
 (16-18 Newton meters). ú
 (d)  Connect the cable from the power supply to the connector on the forward side of the exciter. 1) Tighten the connector nut with your fingers.
 S 864-010-C00
 (5)  If the left (upper) exciter was removed, remove the DO-NOT-CLOSE tag and close this circuit breaker:
 (a)  P6 Load Control Center
 1) L IGN

 S 864-011-C00
 (6)  If the right (lower) exciter was removed, remove the DO-NOT-CLOSE tag and close this circuit breaker:
 (a)  P6 Load Control Center
 1) R IGN

 S 754-012-C00
 (7)  
Do an audible check of the operation of the igniter plug
 (AMM 74-00-00/501).

 (8)  
Close the left and right fan cowl panels (AMM 71-11-02/201).

 S 414-013-C00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 74-11-01
 ALL  ú ú C02.1 Page 405 ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
IGNITION EXCITER - INSPECTION/CHECK
___________________________________
 TASK 74-11-01-206-001-C00
 1.  Inspection of the Ignition Exciter__________________________________
 A. Equipment
 (1)  
Brush - Stiff Bristle

 (2)  
Solvent - Stoddard, CP-2011 (AMM 70-10-01/201)

 B. References
 (1)  
AMM 70-10-01/201, Consumable Materials

 (2)  
AMM 71-11-02/201, Fan Cowl Panels

 C. Access
 (1)  
Location Zones 503 Engine No. 1 - Compressor Case at the 11 o'clock 603 Engine No. 2 - Compressor Case at the 11 o'clock

 (2)  
Access Panels
 5737L Engine No. 1 - Right Fan Cowl Panel
 5837R Engine No. 2 - Right Fan Cowl Panel

 D. Procedure (Fig. 601)
 S 016-010-C00
 (1)  Open the right fan cowl panel (AMM 71-11-02/201).
 S 036-015-C00
 WARNING:_______THE IGNITION SYSTEM VOLTAGE IS DANGEROUSLY HIGH. DO NOT TOUCH THE IGNITION COMPONENTS UNTIL YOU DO THE PROCEDURE THAT FOLLOWS. THIS PROCEDURE WILL RELEASE THE HIGH VOLTAGE FROM THE IGNITION EXCITER. IF YOU DO NOT OBEY THIS PROCEDURE, INJURY TO PERSONS CAN OCCUR.
 (2)  Do these steps to release the high voltage from the ignition exciter:
 (a)  
Set the start switch to the OFF position.

 (b)  
Stop (wait) for a minimum of 2 minutes.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 點火 IGNITION(8)