(2)  
26-15-00/501, APU Fire Detection

 (3)  
IPC 26-15-02 Fig. 2

 (4)  
WDM 26-15-11

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-15-02
 ALL  ú ú 12 Page 407 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (5)  
SSM 26-15-01

 B.
Access

 (1)  
Location Zone
 317 APU Compartment, LH
 318 APU Compartment, RH

 (2)  
Access Panel
 317A Door - Access - APU
 318A Door - Access - APU

 C.
Procedure

 S 864-059
 (1)  Open the circuit breakers listed below and attach DO-NOT-CLOSE identifiers:
 (a)  P6 Main Power Distribution Panel 1) 6C5 ALTN PWR LOOP A APU FIRE/BLD DUCT OVHT 2) 6C6 FIRE SW UNLOCK 3) 6H14 APU FIRE/BLD DUCT OVHT LOOP A 4) 6H15 APU FIRE/BLD DUCT OVHT LOOP B
 S 014-060
 (2)  
Open the APU access doors, and install the rods to the support doors.

 S 034-061

 (3)  
Disconnect the electrical connectors DM216 or DM217 (8) at both ends of detector element (13).

 S 034-115

 (4)  
Install the protective caps on both ends of detector element.

 S 034-062
 CAUTION:_______DO NOT TWIST OR SHARPLY BEND THE DETECTOR ELEMENT. THIS MAY DAMAGE THE DETECTOR ELEMENT.
 (5)  Remove the retaining nuts (7) which hold detector electrical connector (8) in the end bracket (2), at both ends of detector.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-15-02
 ALL  ú ú 13 Page 408 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 034-063
 (6)  
Remove the copper gasket (9).

 S 034-064

 (7)  
Remove the end brackets (2) from the support. Upper Detector Element : Screws (1, 4), washer (9), nuts (3, 6). Lower Detector Element: screw (17), nut (14).

 S 034-065

 (8)  
For vertical part of the upper detector element, remove the screws (4) and nuts (6) to release the detecor assembly from support.

 S 034-066

 (9)  
For horizontal part of the upper detector element, remove the P-clamps (18), screws (4), washers (9), and nuts (6).

 S 024-184

 (10)
 For the lower detector element, remove the P-clamps (18), screws (17), and nuts (14) to release the detector assembly from the support bracket.

 S 024-067

 (11)
 Remove the detector assembly containing the detector element (10) or (19) with the support tube (11).

 TASK 26-15-02-404-080
 5. Install APU Fire Detector Assembly (Fig. 401)
__________________________________
 A. Standard Tools and Equipment
 (1)  Ohmmeter - Accuracy |0.001 ohm Minimum 0.001 ohm
 B. Parts
 ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT | FIG | ITEM | ................................................................................ | 401 | 1 | Screw | 26-15-02| 02 | 05 | | | 3 | Nut | | | 15 | | | 4 | Screw | | | 105 | | | 6 | Nut | | | 120 | | | 9 | Washer | | | 110 | | | 10 | Detector Assembly - Upper | | | 195 | | | 14 | Nut | | | 230 | | | 15 | Detector Assembly - Lower | | | 210 | | | 17 | Screw | | | 225 | 2......…........…...................................…..........….....….........1
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-15-02
 ALL  ú ú 02 Page 409 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 防火 FIRE PROTECTION 1(101)