(2)  
G00000 Paint - Touch-up, 2600-03

 C. References
 (1)  
26-16-51/401, Equipment Cooling Smoke Detector

 (2)  
IPC 26-16-01 Fig. 05

 D. Access
 (1)  Location Zone 121 Forward Cargo Container Compartment Forward Half LH
 E. Procedure
 S 022-010
 (1)  
Remove the smoke detector (Ref 26-16-51/401).

 S 162-021

 (2)  
Do a check on the inner surface of the smoke detector cell for insects or dirt.

 NOTE: Such contamination can cause an incorrect failure indication.
____
 S 162-020
 (3)  Blow out the contamination with the dry compressed air with the pressure less than 15 psig.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-16-51
 ALL  ú ú 01 Page 203 ú Jun 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 142-022
 (4)  Remove the contamination found on the smoke detector wall with a soft bristle brush.
 S 112-023
 WARNING:_______DO NOT BREATHE THE GAS FROM THE SOLVENT. USE RESPIRATORY EQUIPMENT FOR PROTECTION IF IT IS NECESSARY. MAKE SURE THERE IS A GOOD FLOW OF AIR IN THE AREA. DO NOT GET THE SOLVENT IN YOUR EYES, ON YOUR SKIN, OR ON YOUR CLOTHING. KEEP SOURCES OF IGNITION AWAY FROM THE AREA. THE SOLVENTS ARE POISONOUS AND FLAMMABLE AND CAN CAUSE INJURY TO PERSONS.
 CAUTION: DO NOT PERMIT THE SOLVENTS TO TOUCH PLASTICS, CONTROL CABLES,
_______ LUBRICATED AREAS, DECALS, OR PAINTS. THE SOLVENTS CAN CAUSE DAMAGE.
 (5)  
Clean the smoke detector wall with solvent trichloroethane 1:1:1 or naphtha.

 S 212-011

 (6)  
Do a check on the inner surface of the smoke detectors for scratches or shiny areas.

 S 162-012

 (7)  
Make sure the smoke detector cell is clean.

 S 372-024

 (8)  
If the smoke detector has scratches or shiny areas, apply a layer of the paint.

 S 212-014

 (9)  
Make sure there is no damage to the cover gasket before you install the cover.

 (a)  If the gasket is damaged, replace it.

 (10)
 Install the smoke detector (Ref 26-16-51/401).

 S 422-016
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-16-51
 ALL  ú ú 01 Page 204 ú Jun 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 EQUIPMENT COOLING SMOKE DETECTOR - REMOVAL/INSTALLATION
_______________________________________________________
 1.  General_______
 A.  This section contains two tasks. The first task removes the equipment cooling smoke detector. The second task installs the equipment cooling smoke detector.
 B.  To get access to the smoke detector, M7931, remove the left wall lining panel in the forward lower cargo compartment at STA 581.
 C.  If there is an indication that a detector does not work correctly, do a check of the lamp befoe you replace the detector.
 TASK 26-16-51-004-001
 2.  Remove the Smoke Detector (Fig. 401)_________________________
 A.  References
 (1)  
AMM 25-52-01/401, Containerized Cargo Compartment Ceiling and Sidewall Linings

 (2)  
AIPC 26-16-01, Fig. 5

 (3)  
WDM 21-58-12

 B.  Access
 (1)  Location Zone 121 Forward Cargo Container Compartment Forward Half LH
 C.  Procedure
 S 864-002
 (1)  Open this circuit breaker on the main power distribution panel, P6, and attach a DO-NOT-CLOSE tag:
 (a)  6J35, E/E COOLING SMOKE IND TEST
 S 014-003
 (2)  
Get access to the smoke detector through the forward lower cargo compartment at STA 581 (AMM 25-52-01/401).

 (3)  
Disconnect the electrical connector, DM7931, on the smoke detector.