S 862-076
(1) Make sure the flight leg does not change during maintenance:
(a)
Show page 2 of the CMC MENU on a CDU.
(b)
Push the LSK that is adjacent to <OTHER FUNCTIONS.
(c)
Push the LSK that is adjacent to INHIBIT FLT LEG ROLL>.
NOTE:____*FLT LEG ROLL INHIBITED shows on the CDU. The flight leg will not change in the left CMC or the right CMC.
S 862-077
(2) After maintenance is complete, do these steps so that the flight leg will change for the subsequent flight:
(a)
Push the LSK that is adjacent to <OTHER FUNCTIONS on page 2 of the CMC MENU.
(b)
Push the LSK that is adjacent to ENABLE FLT LEG ROLL>.
NOTE:____*FLT LEG ROLL ENABLED shows. The flight leg of the left CMC and the right CMC will change on the subsequent flight.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
45-10-00
ALL ú ú 27 Page 244 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE/CMCS BITE MANUAL
PUSH THIS LSK TO ALLOW THE FLIGHT LEG TO CHANGE THE NEXT TIME THE FIRST ENGINE IS STARTED (OR, IF ENGINES ARE RUNNING, WHEN THE LAST DOOR IS CLOSED)
Manual Flight Leg Control
Figure 210A
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
45-10-00
ALL ú
ú 10 Page 245
ú Jun 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
B49066
A
747-400 MAINTENANCE/CMCS BITE MANUAL
D. Separate Flight Leg for Engine Runs
NOTE: When you do engine runs, you must make a selection of ENABLE
____ FLT LEG ROLL> after the engine runs are completed.
S 862-078
(1) Make a separate flight leg for engine runs:
(a)
Make sure that the left and center IRUs or the left and right IRUs are on. (The IRUs can be in ALIGN, NAV, or ATT mode.)
(b)
Do the engine runs.
NOTE: When you do the first engine run, the flight leg
____ automatically changes. The CMCs collect all the engine run data in the new flight leg.
S 862-079
(2) When all engine runs are completed, do these steps so that the flight leg will change on the subsequent flight:
(a)
Push the LSK that is adjacent to <OTHER FUNCTIONS on page 2 of the CMC MENU.
(b)
Push the LSK that is adjacent to ENABLE FLT LEG ROLL>.
NOTE:____FLT LEG ROLL ENABLED shows. The flight leg will change on the subsequent flight in the left and right CMCs.
TASK 45-10-00-972-053
12. Printer Report of a CDU Display (Fig. 211)
_______________________________
A. General
(1) If a CDU display has a REPORT> prompt on it, you can make a printer report of that display. This procedure contains the steps to make a report of a CDU display.
B. Access
(1) Location zones
221 Control Cabin, LH
222 Control Cabin, RH
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
45-10-00
ALL ú ú 23 Page 246 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE/CMCS BITE MANUAL
Printer Report
Figure 211
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
45-10-00
ALL ú
ú 02 Page 247
ú Jun 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE/CMCS BITE MANUAL
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 中央維護計算機系統(44)
