(h)
Tighten the chromel nuts (smaller terminal studs) to 15-18 pound-inches (1.695-2.034 newton-meters).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-07
ALL ú ú N01A Page 462 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(i)
Install the lockwire from the coupling nut to the adapter.
(j)
Tighten the bolt that attaches the clamp and ground strap to the bracket on the housing to 36-40 pound-inches (4.067-4.519 newton-meters).
S 424-150-N00
(3)
Adjust the W5 harness to get the necessary clearances.
S 424-149-N00
(4)
Install the clamps on the harness at the tape marker locations.
(a)
Make sure you can see the tape marker on both sides of the clamp.
S 424-148-N00
(5)
Install the clamps at all the clamp locations.
S 424-147-N00
(6)
Lubricate the threads of the nuts and bolts with engine oil.
S 424-146-N00
(7)
Loosely install the bolts and nuts to the clamps for the W5 wiring
harness.
S 424-145-N00
(8)
Make sure the wiring harnesses are not pulled too tightly between
any two clamps.
S 424-144-N00
(9)
Make sure the wiring harness does not touch any engine parts.
S 424-143-N00
(10)
Make sure the wiring harness is not pulled too tightly where the
wiring harness attaches to the connectors.
S 424-142-N00
(11)
Tighten all the nuts and bolts for the clamps on the W5 harness to
36-40 pound-inches (4.067-4.519 newton-meters).
NOTE: Make sure there is clearance between the W3 and W5 wiring
____ harnesses and hardware near the lower left of the front side of the gearbox.
H. Put the Airplane Back to its Usual Condition
S 414-174-N00
WARNING: OBEY THE INSTRUCTIONS IN AMM 78-31-00/201 WHEN YOU CLOSE THE
_______
THRUST REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS,
INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(1) Close the thrust reversers (AMM 78-31-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-07
ALL ú ú N01A Page 463 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
S 414-167-N00
(2) Close the core cowl panels (AMM 71-11-06/201).
S 414-166-N00
(3) Close the fan cowl panels (AMM 71-11-04/201).
S 444-165-N00
(4) Do the activation procedure for the thrust reverser (AMM 78-31-00/201).
S 864-164-N00
(5) For the applicable engine, remove the DO-NOT-CLOSE tags and close these circuit breakers as follows:
(a) P6 Main Power Distribution Panel 1) 6F15 ENG 1 PERF SOL PWR A 2) 6F16 ENG 1 PERF SOL PWR B 3) 6G15 SCU ALT PWR ENG 1 4) 6G23 ENG SCU 1 5) 6E15 ENG 2 PERF SOL PWR A 6) 6E16 ENG 2 PERF SOL PWR B 7) 6G16 SCU ALT PWR ENG 2 8) 6G24 ENG SCU 2 9) 6D15 ENG 3 PERF SOL PWR A 10) 6D16 ENG 3 PERF SOL PWR B 11) 6G17 SCU ALT PWR ENG 3 12) 6G25 ENG SCU 3 13) 6C15 ENG 4 PERF SOL PWR A 14) 6C16 ENG 4 PERF SOL PWR B
15) 6G18 SCU ALT PWR ENG 4 16) 6G26 ENG SCU 4
S 714-163-N00
(6) Do the Test No. 6 - Electronic Engine Control (EEC) Idle Test and No. 7 - EEC Static Test (AMM 71-00-00/501).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-07
ALL ú ú N01A Page 464 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
TASK 73-21-07-004-175-N00
8. Remove the W6 EEC Wiring Harness (Fig. 405)
________________________________
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 發動機燃油和控制 2(58)
