S 865-005
 (a)  Warning System (Ref 31-51-00).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 11 Page 505 ú Sep 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 (b)  
Master Dim and Test (Ref 33-16-00).

 (c)  
Air Data Computer (Ref 34-12-00).

 (d)  
Inertial Reference System (Ref 34-21-00).

 (e)  
Flight Instrument System (Ref 34-22-00).

 (f)  
Radio Altimeter System (Ref 34-33-00).

 (g)  
Flight Management Computer System (Ref 34-61-00).

 S 865-007
 WARNING: MAKE SURE ALL PERSONS AND STANDS ARE CLEAR OF CONTROL
_______ SURFACES AND CONTROL COLUMNS BEFORE HYDRAULIC SYSTEMS ARE PRESSURIZED. CONTROL SURFACES CAN MOVE WHEN AN HYDRAULIC SYSTEM IS PRESSURIZED AND CAUSE INJURY TO PERSONS.
 (5)  
Make sure the L, C and R FLT CONTROL SHUTOFF valves are open.

 S 865-009

 (6)  
Supply hydraulic power (Ref 29-11-00).

 S 865-010

 (7)  
Make sure the MCDP is off.

 S 865-011

 (8)  
Align the left, center, and right Inertial Reference Units in NAV MODE (Ref 34-21-00).

 NOTE: Approximately 10 minutes are necessary to align the IRU's.
____ The steps before the "Test AFDS Operation" step can be done during this time.
 S 865-012
 (9)  On the P1-1 panel, set the captain's instrument source select switches to these positions:
 (a)  FLT DIR switch to L.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 11 Page 506 ú Dec 20/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 (b)  ADC, FMC, EFI, and IRS switches to normal (ALTN indication on switch does not show).
 S 865-013
 (10) On the P3-3 panel, set the first officer's instrument source select switches to these positions:
 (a)  
FLT DIR switch to R.

 (b)  
ADC, FMC, EFI, and IRS switches to normal (ALTN indication on switch does not show).

 S 865-014
 (11) Set the A/T switch and the two F/D switches on the MCP to OFF.
 E. Test AFDS Operation
 S 715-015
 (1)  Do these steps to do a check of the A/P DISC light, AUTOPILOT light, and MCP switch-lights:
 (a)  Make sure the A/P DISC and AUTOPILOT lights on the P1-3 panel are not on.
 NOTE: If lights are on, push A/P disconnect switch two
____ times to cancel the warning.
 (b)  
On the P5 panel, set the IND LTS DIM/BRT switch on the right lighting control panel to BRT.

 (c)  
On the P5 panel, push the TEST switch on the right lighting control panel to set Master Dim and Test to on.

 (d)  
Make sure the A/P DISC light and AUTOPILOT light are on.

 (e)  
Make sure the bottom half of the MCP switch-lights (dot-bar matrices) are on.

 (f)  
Push the TEST switch on the right lighting control panel to set the test to off.

 S 715-016
 (2)  Do these steps to do a check of the MCP light-plate and
 switch-lights:

 (a)  On the P5 panel, turn the PANEL/FLOOD GLARESHIELD switch on the left lighting control panel full clockwise (CW).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 06 Page 507 ú May 20/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 (b)  
Make sure the MCP light-plate and the top half of the
 switch-lights are on.

 (c)  
Turn the PANEL/FLOOD GLARESHIELD switch counterclockwise (CCW).

 (d)  
Make sure the MCP light-plate and switch-lights dim.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 1(86)