(2.) Blow tubingcleanand dry with a stream of dry nitrogen. Exercisecareto ensure that the interiorof the tubing and fittings are thoroughly cleaned.
(b)
Second Method: (1.) Flush with Specification TT-N-95 naphtha. (2.) Blow cleanand dry off all solvent withwater-pumped air. (3.) Flush with SpecificationMIL-F-566anti-icingfluid or SpecificationTT-1-735alcohol. (4.) Rinse thoroughly with fresh water. (5.) Dry thoroughly with a stream of clean, dried,filtered air or by heating to a temperature of
250°Fto 300°F as required.
(6.) The solventsmaybe reused provided they do not becomeexcessivelycontaminatedwith oil. This condition shall be determined asfollows: (a.) Completelyevaporate100 milliliters of the liquid in a weighed glass dish. Evaporation
may be accomplishedby heating at 200°F for approximately 1/2 hour. (b.) After evaporation,cool and weighthe residue. Do not use the solventif the residue exceeds100milligramsin weight.
(c) Third Method: (1.) Flush with hot inhibited alkalinecleaneruntil free from oil and grease. (2.) Rinse thoroughlywith fresh water. (3.) Drythoroughly with a stream of clean, dry,filtered air or by heating at a temperature of
250°F to 300°F as required.
17. FaceMaskCleaning
The pilot, copilot, and passenger maskscan all be cleaned. Disregard those instructions not pertainingto the particularmask.
(a)
Remove the microphonefromthe mask.
(b)
Remove the spongerubberdiscsfromthe mask turrets. Do not usesoap to clean sponge rubberdiscs;this could deterioratethe rubber and give off unpleasant odors. Clean in clear water and squeezedry.
(c)
Wash the rest of the mask with a very mild solution of soapand water.
(d)
Rinsethe maskthoroughlyto remove all traces of soap.
(e)
Makesure the sidesof the breathing bag do not sticktogetherwhiledrying;this actionmay decreasethe life of the rubberin the bag. The mask can be sterilizedwith a solution of 70 percentSpecificationTT-1-735alcohol.
EFFECTIVITY:
35-10-00 PAGE 7
35-10-00Jan
PIPER AIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCEMANUAL
CHAPTER 36
LIST OF EFFECTIVE PAGES
CHAPTER CHAPTER
SECTION PAGE DATE SECTION PAGE DATE
36-EFFECTIVITY 1 Jan 10/90
36-CONTENTS 1 Jan 10/90
36-00-00 1 Jan 10/90
36-10-00 1 Jan 10/90
36-10-00 2 Jan 10/90
36-10-00 3 Jan 10/90
36-10-00 4 Jan 10/90
36-10-00 5 Jan 10/90
36-10-00 6 Jan 10/90
36-10-00 7 Jan 10/90
36-10-00 8 Jan 10/90
36-10-00 9 Jan 10/90
LISTOF EFFECTIVE PAGESJan10/90
PIPERAIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCEMANUAL
CHAPTER 36 -PNEUMATIC
TABLE OF CONTENTS
SUBJECT CHAPTER PAGE
36-00-00
General Description and Operation 1
36-10-00
Distribution 1
Component Detailed Descriptions 1
Bleed Air Shutoff Valve Removal 3
Bleed Air Shutoff Valve Installation 3
Intercooler Removal 3
Intercooler Installation 3
Bleed Air Overtemperature Switches Removal 4
Bleed Air Overtemperature Switches Installation 4
PneumaticSystem Check Valves Removal 4
Pneumatic System Check Valves Installation 4
Pressure Regulator and Relief Valve Removal 4
Pressure Regulator and Relief Valve Installation 4
Ejector Removal 5
Ejector Installation 5
Deicer Valves Removal 5
Deicer Valves Installation 5
Pressure Switches Removal 5
Pressure Switches Installation 5
Check Valve Removal 6
Check Valve Installation 6
Vacuum Regulator Removal 6
Vacuum Regulator Installation 6
Gyro Central Air Inlet Filter Removal 6
Gyro Central Air Inlet Filter Installation 6
Proof Pressure and Leakage Test of Pneumatic Lines 7
EFFECTIVITY: 040-999
CONTENTSan 10/90
PIPERAIRCRAFT
PA-42-720(AdvancedTrainer)
MAINTENANCEMANUAL
Pneumatic System
A General Description and Operation
Pneumaticsystem pressure is obtained frombleedair outlets of each engine compressor stage.
Bleed air for the pneumatic systemis taken from the main bleed line upstream of the environmental
systembleed air shutoff valve.Pneumaticsystem bleed air is supplied when the engines areoperating
and cannot be shut off. The bleed air moves onto the intercoolers,locatedin the engine nacelles,
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：夏延飛機維護手冊 Cheyenne IIIA PA-42-720 AMM 2(83)
