%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Remove the trim/cover from the front face of the baggage compartment frame. Pull the rear seat-backs forward.
(2) ACK E-01: S Disconnect the cable for the RCPI at the in-line connector. Jolliet JE2-NG: S Disconnect the cable for the RCS at the connector screws. At the ELT.
(3) Disconnect the co-axial cable for the antenna at the ELT BNC connector.
(4) Release the clamps which hold the ELT in its mounting and remove the ELT from the airplane. ACK: 2 clamps. Jolliet: 1 clamp.
Doc # 6.02.01 Page 201
Rev. 4 09 Jan 2003
25-60-00
AMM
B. Install the ELT
%
%
%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Move the ELT into position into its mounting.
(2) Close and secure the clamps which hold the ELT. ACK: 2 clamps. Jolliet: 1 clamp.
(3) ACK E-01: S Connect the cable from the RCPI to the ELT at the in-line connector. Jolliet JE2-NG: S Connect the cable from the RCS to the ELT at the connector screws.
(4) Connect the co-axial cable from the antenna to the ELT at the BNC connector.
(5) Do a test for the correct operation of the ELT. Refer to Paragraph 3.
(6) Install the trim/cover to the front face of the baggage compartment frame.
Page 202 Doc # 6.02.01 09 Jan 2003 Rev. 4
25-60-00
Equipment/Furnishings
3. ELT Functional Test
Note: Do this test only during the first 5 minutes of each hour. If you are at a location with a control tower or other monitoring facility, tell them before you do the test.
Note: For maintenance done to FAR 91 (airplanes registered in the USA) an additional functional test of the ELT is required. Refer to FAA Action Notice 8150.3 for more data.
%
%
%
%
%
%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Set the ALT/BAT switch (Lycoming version) or ELECTRIC MASTER key switch (TAE version) to ON.
(2) Set the AVIONIC MASTER switch to ON.
(3) Set the radio to receive on 121.5 MHz.
(4) Set the ELT to ON (ACK) or MANU (Jolliet). The test must not last longer than 3 audio sweeps.
(5) Monitor the radio for the ELT sweep tone.
(6) Set the ELT to OFF (ACK) or OFF/RST (Jolliet).
(7) Set the AVIONIC MASTER switch to OFF.
(8) Set the ALT/BAT switch (Lycoming version) or ELECTRIC MASTER key switch (TAE version) to OFF.
Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003
25-60-00
AMM
% Figure 2: Replace the ELT Batteries (ACK E-01)
25-60-00
Equipment/Furnishings
4. Replace the ELT Batteries % A. ACK E-01
You must only use Duracell MN1300 alkaline batteries which are dated by the manufacturer. You must change the batteries on or before the date shown on the batteries. You must replace all of the batteries at the same time. Make sure that all the batteries are identified with the same date.
% You must replace the batteries after a cumulative transmission time of one hour.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 2(81)
