曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Accuracy on Instrument Approach Procedures  ADF needle oscillations < ± 5°. (2070) See Note 1  Commissioning and Annual Following Instrument Approach Procedure 
Coverage  >70 microvolts per metre. (2071)  Commissioning Orbit at the DOC or 15NM, whichever is the smaller, at Minimum Safe Altitude. 
Identification  Correctness, clarity and proper tone. (2072)  Commissioning and Annual Throughout the flight inspection. 
Station passage  Reversal without excessive ADF needle swing around station passage. ADF needle oscillations <± 10° throughout the remainder of the radial. (2073) See Note 1  Commissioning and Annual Two radials 90 degrees apart. From 5NM to 5NM past the station. 

NOTE 1:
Periods of out of limits are acceptable as long as:
a) they are oscillatory in nature rather than one sided and do not exceed 8 seconds for the check of the DOC, Airways and Holding patterns and 4 seconds for Instrument Approach procedures,
b) the pilot reports that the usability of the NDB is acceptable and that the NDB satisfactorily supports the Airway/Holding Pattern/Approach Procedure.
4.9  Analysis of Flight Inspection Records
4.9.1  The Air Traffic Service Provider shall analyse the flight inspection report at the earliest opportunity for operational systems and prior to entering a facility into operational service, to ensure that the flight inspection requirements are met (2345).
4.9.2  The Air Traffic Service Provider shall address any deficiencies or non-compliance to ensure a safe service is provided (2346).
4.9.3  An Air Traffic Service Provider may delegate the task of analysing the flight inspection report to a third party specialist organisation. This may be the flight inspection organisation that provided the report. The responsibility for addressing any deficiencies identified remains with the Air Traffic Service Provider (2347).
4.9.4  The person who conducts the analysis shall be competent to do so (2348). NOTE: This may include training on a specific flight inspection report format.
4.10  Off-Shore Requirements
4.10.1  Particular attention shall be given to the design and location of the beacon antenna to ensure an effective coverage pattern (2074).
4.10.2  The beacon shall be capable of operating on the frequencies laid down in the UK AIP ENR, Chapter 1.15, Off-shore Operations, for both mobile and fixed operations (2075). As frequencies are shared for mobile installations it is imperative that any commissioning or testing of the NDB shall be carried out with due regard to preventing interference to other users (2076).
4.10.3  Procedures shall exist to prevent simultaneous operation with other co-channel beacons (2077).
INTENTIONALLY LEFT BLANK
NAV 03  VHF Omnidirectional Range (VOR) Flight Inspection Types and Requirements
Part 1 Preliminary Material
1 Introduction
It is a requirement that all VOR systems and associated Instrument Flight Procedures are checked by flight inspection at prescribed intervals.
2 Scope
This document defines the following:
.  
Parameters to be measured;

.  
Profiles to be flown to demonstrate the VOR is suitable to support Instrument Flight Procedures;

.  
Measurement methods;

.  
Flight inspection tolerance limits;

.  
Flight Inspection type and Interval.

Part 2 Requirements
3  Safety Objective
To ensure that the VOR provides an accurate and uncorrupted source of guidance information within the Designated Operational Coverage.
4  Parameters To Be Measured
During Commissioning and Routine inspection the parameters in the following table shall be measured for all available transmitters and be within limits:
Parameter  Limits 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CAP 670 Air Traffic Services Safety Requirements 2(67)