曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

If the airspeed is less than 80 kts, a system failure that reduces the level of safety causes the ENG REVERSER L(R) advisory message to be shown.
Status Display
The ENG REVERSER L(R) status message is shown for any failures that may reduce the system level of safety.
The ENG REVERSER SNSR L(R) status message is shown for sensor or sensor circuit faults. This message is not shown if the ENG REVERSER L(R) message is shown.
EPCS Maintenance Page
The thrust reverser sleeve position is shown on the EPCS maintenance page 1. For each EEC channel, the data is shown for both the left and right sleeves. The range is from zero percent (fully retracted) to 100 percent (fully extended).

EFFECTIVITY BEJ ALL  78-36-00 
Page 18 
D633W101-BEJ  May 05/2003 

 

T/R INDICATING AND FAULT DETECTION -INDICATIONS

EFFECTIVITY BEJ ALL  78-36-00 
Page 19 
D633W101-BEJ  May 05/2003 

 

T/R INDICATING AND FAULT DETECTION -FUNCTIONAL DESCRIPTION -EEC INPUTS

General

The electronic engine control (EEC) gets data from thrust reverser (T/R) sensors to make sure these conditions occur:
*
The isolation valve sends pressure to the hydraulic actuators only during thrust reverser extend and retract operation

*
The engine operates above idle thrust only when the thrust reverser is in the fully extended position

*
The flight deck gets proper indication of normal and non-normal thrust reverser operation.

This data comes from the hydraulic pressure switch on the isolation valve and the rotary variable differential transducers (RVDT).
Hydraulic Pressure Switch

The hydraulic pressure switch signal goes to both channels of the EEC. The switch closes when the isolation valve is open. If the switch shows that the valve is open without an open command from the EEC, the EEC sends a signal to the AIMS to show advisory and status messages.
If the isolation valve does not open when it gets an EEC command to open, the EEC sends a signal to the AIMS for the central maintenance computing system (CMCS) maintenance messages.
Thrust Reverser Position Transducer (RVDT)
Each EEC channel gets data from the rotary variable differential transducer (RVDT) on each non-locking (upper) hydraulic actuator. The EEC uses this data to:
*
Operate the thrust lever interlock actuator

*
Send indication data to the AIMS

*
Schedule reverse thrust.

When either T/R sleeve extension is 5 percent, the EEC sends a signal to the AIMS to show the amber REV indication on the EICAS display. This tells the flight crew that the T/R is released and in transit.
When the average of the sleeve extensions is 60 percent, the EEC sends a signal to the ELMS to operate the thrust lever interlock actuator. This removes the block that prevents the flight crew from commanding more than reverse idle thrust.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 發動機排氣 Engine Exhaust PW 777 AIRCRAFT MAINTENANCE MANUAL(55)