曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

a) Install servo—actuator on work bench according to Detail A.
b) Dynamometer uncoupled.
c) Connect electrically according to Detail B.
d) Close "K" switch ; this actuates the engagement and the crankpin turns ; to reverse direction of rotation, tilt "J".
e) Open "K" to stop ; attach the dynamometer to the crankpin hinge line.
f) Close "K".
g) Read corresponding force on the dynamometer and compare it with Paragraph 3D.
h) Open "K".
i) Reset if necessary, then safety nut in position — refer to Paragraph 3C.
2) Procedure for pitch trim (Figures 204 and 205)
a) Install servo—actuator on work bench according to Figure 205.
b) Dynamometer uncoupled.
c) Connect electrically according to Figure 204, Detail B.
d) Close "K" switch ; this actuates the engagement and the pulley—capstan turns ; matchmark the direction of rotation and reverse through "J" if necessary.
e) Close "K" and read the value of stress "Fl" on dynamometer. This stress reduced of 11 lbs (5 kg) "F2" corresponding to the cable tension, represents the maximum differential stress supplied by the pulley—capstan, provided that you check if this is the clutch skidding and not the cable sliding on the pulley—capstan.
NOTE : If the cable slides, increase the weight which tightens the cable until you get the adherence of cable / pulley—capstan.
f) Apply the formula : "F" = Fl — F2
F : limit stress of the servo—actuator in kg Fl : stress read on the dynamometer in kg F2 : weight used for the cable tension in kg
g) Open "K".
h) Compare "F" with the tolerances given in the table Paragraph 3D.
i) Reset if necessary, then safety nut in position — refer to Paragraph 3C.
ACAC
Validity : CENTURY 31 22-11 Page 207
00 (AM) DEC 99

 
Rondelles Washers
Etabli
Work bench
 
 
"I"
 
Prise de force maneton Hinge line
Mesure de la traction Traction measurement
Dynamometre
Dynamometer
 
Force de traction
Traction load
Roll and pitch servo—actuator — Adjustment / Test
Figure 204
ACAC
Validity : CENTURY 31 22-11-00 (AM) Page 208
DEC 99
 
Pitch trim servo—actuator — Adjustment / Test
Figure 205
ACAC
Validity : CENTURY 31 22-11 00Page 209
(Am) DEC 99
 
C. Setting of servo—actuator stress limiters
— Remove stress limiters so as to test stress limiter on work bench — see Paragraph 2B.
— Stress limit is defined at the link (roll and pitch) and at the cable (pitch trim). It must be measured with the dynamometer in the rotation plane of the hinge line, the pull direction must draw a 90° angle with the lever arm.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 22 AUTO FLIGHT TB20飛機維護手冊 22 自動飛行(14)