XIA 003-004, 008-011; AIRPLANES WITH EMERGENCY LIGHTING INSTALLED ON THE SEAT
SUBTASK 25-22-01-860-003
(4)  Disconnect the electrical connectors for the emergency lighting installed on the seat.
XIA 003-004, 008-011
SUBTASK 25-22-01-030-001
(5)  For Business Class seats, do these steps:
NOTE: This task applies to BE Aero Millennium 87989 series seats.

(a)  
Loosen the anti-rattle nut on the forward leg track fitting to the fully up position.

(b)  
Loosen the screw on the rear leg track fitting to the fully up position.

SUBTASK 25-22-01-030-002
(6)  For Economy Class seats, do these steps:
(a)  
Loosen the front fitting screw to the fully up position.

(b)  
Loosen the rear seat fitting assembly to the fully up position.

EFFECTIVITY:
25-22-01
003‐004, 008‐011
PAGE 401 JUNE 10/11
AAR PROPRIETARY - Do not copy without express permission of AAR
SUBTASK 25-22-01-010-008
(7)  If installed, remove passenger life vest located in life vest container. NOTE: Disregard if seat is not being routed to shop.
SUBTASK 25-22-01-860-018
(8)  Route seat to shop if necessary. ------------------------- END OF TASK ---------------------------
TASK 25-22-01-400-802
3.  Passenger Seat Installation
(Figure 401)
A.  Location Zones
Zone Area

200  Upper Half of Fuselage
B.  Passenger Seat Installation Preparation
XIA 003-004,008-011
SUBTASK 25-22-01-420-290
(1)  For Business Class seats, do these steps:
NOTE: This task applies to BE Aero Millennium 87989 series seats.

(a)  
Make sure the anti-rattle nut on the forward leg track fitting is loosened until it is in the fully up position.

(b)  
Make sure the screw on the rear leg track fitting is loosened until it is in the fully up position.

SUBTASK 25-22-01-420-265
(2)  For Economy Class Seats do these steps:
(a)  
Make sure the front fitting is loosened until it is in the fully up position.

(b)  
Make sure the shear pin assembly on the rear leg track fitting is loosened until it is in the fully up position.

XIA 003-004, 008-011
C.  Passenger Seat Track Fitting Tightening Procedure
SUBTASK 25-22-01-420-002
(1)  Install the seat in the tracks.
EFFECTIVITY: 003‐004, 008‐011  25-22-01 PAGE 402 
JUNE 10/11 
AAR PROPRIETARY - Do not copy without express permission of AAR 

SUBTASK 25-22-01-210-001
(2)  Make sure the seat track fittings are correctly installed in the seat tracks.
(a)  
Tighten the fittings.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (ICA) 持續(xù)適航說明(5)