曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(3)  Carefully remove the partition [1] from its location.
SUBTASK 25-24-16-020-021
(4)  Do these steps to remove the outboard top support attachment (Figure 404): NOTE: It is not necessary to disconnect or remove the outboard A/C top support
EFFECTIVITY: 003‐004, 008‐011  attachment to remove the partition [1].  25-24-16 PAGE 401 AUG 25/11 
AAR PROPRIETARY - Do not copy without express permission of AAR 

(a)  
Loosen the setscrew [47] on the bottom of the partition attachment assembly [45].

(b)  
Remove the locking screw [48] and the washer [49] on the partition attachment assembly [45].

(c)  
Rotate the partition attachment assembly [45] and the extrusion attachment assembly [46] a small amount to remove them.

------------------------- END OF TASK ---------------------------
3.  Top Attachment Removal
(Figure 404)
A.  General
(1)  This task is for a partition with a top attachment(s).
B.  Location Zones
Zone Area

200   Upper Half of Fuselage
C.  Procedure
SUBTASK 25-24-16-020-024
(1)  Do these steps to disconnect the inboard top support attachment (Figure 404):
(a)  
Loosen the setscrew [41] on the fitting assembly [40] at the top of the partition [1].

(b)  
Push the latches of the fitting assembly [40] toward each other to disconnect the fitting assembly [40] from the stowage bin/PSU extrusion under the stowage bin.

(c)  
Move the fitting assembly [40] down into the partition [1].

(d)  
Move the latches away from each other to allow more clearance to remove the partition [1].

------------------------- END OF TASK ---------------------------
EFFECTIVITY: 003‐004, 008‐011  25-24-16 PAGE 402 
AUG 25/11 
AAR PROPRIETARY - Do not copy without express permission of AAR 

TASK 25-24-16-000-806
4.  Bottom Attachment Removal
(Figure 403)
A.  General
(1) This task includes the steps to remove the bottom attachment(s).
B.  Location Zones
Zone Area

200  Upper Half of Fuselage
C.  Procedure
SUBTASK 25-24-16-020-026
(1)  To disconnect the lower attachment, do the applicable steps that follow:
(a)  
Remove the applicable attachment hardware, such as a bolt [31], washer(s) [32], nut [33], plug [35], and spacer [36], that attach the partition [1] to the seat track fitting.

(b)  
Loosen the anti-rattle setscrew

(c)  
Disengage the shear plunger from the seat track [9].

(d)  
Move the fitting aft or forward until it moves freely out of the track.

------------------------- END OF TASK ---------------------------TASK 25-24-16-400-801
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (ICA) 持續適航說明(9)