(l)  
Set the switch on the standby Engine Indicator to the AUTO position.

 (m)  
Set the COMPUTER switch on the DISPLAY select panel to the L position.

 (n)  
Make sure that the top display shows the primary engine page and the bottom display shows the secondary engine page.

 (o)  
Make sure that the message L ENG SHUTDOWN and R ENG SHUTDOWN show on the top display.

  ú

 31-41-00
 ALL  ú ú 02 Page 511 ú Sep 28/00

A
757
MAINTENANCE MANUAL

 (p)  
Set the L FUEL CONTROL switch on the control stand to the RUN position.

 (q)  
Make sure that the message L ENG SHUTDOWN does not show on the top display.

 (r)  
Push the L manual override switch under the L FIRE HANDLE on the control stand, panel P10.

 (s)  
Pull, but do not rotate, the left engine fire handle.

 (t)  
Install a DO-NOT-OPERATE tag on the left engine fire handle.

 (u)  
Make sure that the message L ENG SHUTDOWN shows on the top display.

 (v)  
Set the right engine fuel control switch to the RUN position.

 (w)  
Make sure that the message R ENG SHUTDOWN does not show on the top display.

 (x)  
Push the R manual override switch under the R FIRE HANDLE on the control stand, panel P10.

 (y)  
Pull, but do not rotate, the right engine fire handle.

 (z)
Install a DO-NOT-OPERATE tag on the right engine fire handle. (aa) Make sure that the message R ENG SHUTDOWN shows on the top

 display. (ab) Push the STATUS switch on the DISPLAY select panel. (ac) Make sure that the STATUS page and the message R EICAS CMPTR
 shows on bottom display.
 NOTE: If there are more than 11 STATUS messages, R EICAS CMPTR
____
 may show on PAGE 2 of the STATUS pages.

 (ad) Close this circuit breaker on the P11 panel: 1) 11J31, EICAS DISPLAY SW (ae) Make sure that there are no changes in the top or bottom
 displays. (af) Set the COMPUTER switch on the DISPLAY select panel to AUTO. (ag) Make sure that there are no changes in the top or bottom
 displays. (ah) Set the COMPUTER switch to the R position. (ai) Make sure that both displays go out of view. (aj) Set the COMPUTER switch to the AUTO position. (ak) Close this circuit breaker on the P11 panel:
 1) 11J29, EICAS CMPTR RIGHT (al) Make sure that the message R EICAS CMPTR does not show on the
 bottom display. (am) Set the COMPUTER switch to the R position. (an) Make sure that there are no changes in the top or bottom
 displays. (ao) Open this circuit breaker on the P11 panel: 1) 11J2, EICAS CMPTR LEFT (ap) Make sure that the message L EICAS CMPTR shows on the bottom display. (aq) Make sure that the messages L ENG SHUTDOWN and R ENG SHUTDOWN
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 2(66)