曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

The rear ground handling provisions are located on the turbine exhaust case. They consist of holes through the two flanges which accept load pins. The primary ground handling points are on the horizontal centerline on each side of the engine. The flight mount points are utilized as secondary ground handling points. Figure 3-3 shows an illustration with pertinent dimensions of the rear ground handling points. The rear primary ground handling points will react only to vertical and side loads.
3-2-1

ENGINE REMOVAL GROUND HANDLING PROVISIONS Page 3-2 Apr 11/2002
D623N005

3-2-1

ENGINE REMOVAL GROUND HANDLING PROVISIONS Page 3-3 Apr 11/2002
D623N005

3-2-1

ENGINE REMOVAL GROUND HANDLING PROVISIONS Page 3-4 Apr 11/2002
D623N005

3-2-1

ENGINE REMOVAL GROUND HANDLING PROVISIONS Page 3-5 Apr 11/2002
D623N005

3.3 ENGINE OVERHAUL SLING
3.3.1 Engine Overhaul Sling Description
Engine mounts for a sling/hoist are shown in Figure 3-4. These are the secondary points identified in Figure 3-2 and Figure 3-3. No side load provisions are incorporated in these lift points.
The engine sling is mainly used to transport the engine from one cradle to another cradle or workstand. The hook or hoist ring is located off the center of the beam due to the CG location of the engine. A ballast is further employed to fine-tune the weight distribution.
The Boeing-designed sling is part number B71027. Associated workstands and adapters, used with the sling when building up a basic engine to on-wing standards, are:
PRATT & WHITNEY TOOLS  QTY  PART NO. 
PEDESTAL SUPPORTS ADAPTERS TO PEDESTAL SUPPORT BRACKET, LEFT ADAPTER TO PEDESTAL SUPPORT BRACKET, RIGHT SUPPORT BRACKET, FAN CASE PROTECTOR, EEC PANEL  4 3 1 1 1 2 1  PWA 80004 OR 80698 PWA 80005 PWA 80009 PWA 80230 PWA 80269 PWA 81348 PWA 81358 
ALTERNATE STANLEY AVIATION TOOLS 
PEDESTAL KIT OF 4 STANDS AND FITTINGS  1  110746-101 

3-3-1
ENGINE OVERHAUL SLING
Page 3-6 Apr 11/2002
D623N005
 

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT

3-3-1

ENGINE OVERHAUL SLING
Page 3-7 Apr 11/2002 D623N005
 

3.4 ENGINE BOOTSTRAP HANDLING EQUIPMENT
3.4.1 Engine Bootstrap Description
The bootstrap handling system eliminates dependence on heavy handling equipment (e.g., overhead hoists and forklifts). The system includes forward and aft arms with hoists and dynamometers attached. The arms attach to the strut as shown in Figure 3-5. The hoists are attached to an engine cradle/dolly which, in turn, supports the engine at the primary ground handling points. The bootstrap system permits engine installation and removal with the thrust reverser installed.
The forward arms, with dynamometers attached, are used to control engine and cradle roll attitude. The aft arms, with one dynamometer on the inboard side of the engine, are used to control engine and cradle pitch attitude. The dynamometer readings are used to establish the point at which the bootstrap equipment is supporting the weight of the engine.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 PW2000 Series Engine Ground Handling Document 發動機地面處理文件(12)