Twist 2 rods onto center latch component.
4

Twist 2 outer latch components onto 2 rods.
5

Install 2 outer latch components and 2 mount blocks with 4 screws.
6

Install cover with 4 screws.

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
7 Close door and verify door latches engage door striker.
(n)  Install Literature Door (Ref Fig 3001 sheet 2/4) 1
Align literature door with holes in hinge.
2

Attach door to hinge with 4 screws.

(o)  
Install Literature Pocket Trim Assembly (Ref Fig 3001 sheet 2) 1 Open literature pocket door. 2 Attach literature pocket trim assembly with 5 screws and 5 washers.

(p)  
Install Coat Hook (Ref Fig 3001 sheet 2) 1 Pull coat hook lever to open position. 2 Attach coat hook with 2 screws

(q)  
Install Table Inlay Assembly (Ref Fig 3001 sheet 3) 1 Verify that the double.back tape on the back of the table inlay is in good condition.

Replace if necessary.
2 Align table inlay assembly on top of table assembly.
3 Press to engage double.back tape

(r)  Install Table T.bar (Ref Fig 3001 sheet 3) 1 Attach 2 T.bars with 2 screws per T.bar. 2 Slide table assembly over T.bars. 3 Attach T.bars to table assembly with 2 set screws. 4 Install table inlay assembly. Ref Step R. 5 Attach cover with 2 screws. 6 Raise table and verify table is secure and flush with surrounding panels. T.
(s)  Install Table Latch (Ref Fig 3001 sheet 2) 1
Attach table latch with 2 screws.

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
(t)  Install Monitor Shroud (Ref Fig 3001 sheet 2)

Install Monitor see TBD. The following instructions are assuming that the monitor will not be installed at this time.
1 Hook monitor shroud into the video shroud frame assembly.

2  With the top of monitor shroud tilted aft, install two screws into the side of the monitor shroud.
3  Tilt monitor shroud to vertical position.

(u)  
Install LED and Switch PCB assembly (Ref Fig 3001 sheet 8)
1 Open circuit breakers for seat shells.
2 Connect electrical connectors to LED and switch PCB assembly.
3 Attach LED and switch PCB to shell assembly with 2 screws and 2 washers.
4 Install deco panel, forward with eagle.

(v)  
Install Handrails (Back shell and Divider) (Ref Fig 3001 sheet 1) 5 (Verify that the hook and loop tape on the back of the table inlay is in good condition.

Replace if necessary. 6 Place Handrail on seat shell in the same orientation that it was removed. 7 Press down on Handrail to engage hook and loop tape tape.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(43)