(Ref. Fig. 401C/TASK 26-16-15-991-001-B)
**ON A/C 301-302,
(Ref. Fig. 401D/TASK 26-16-15-991-001-C)
**ON A/C 303-399,
(Ref. Fig. 401E/TASK 26-16-15-991-001-E) R **ON A/C 401-499,
R (Ref. Fig. 401F/TASK 26-16-15-991-001-F) **ON A/C 001-049, 051-061, 101-105, 201-203,
Subtask 26-16-15-020-050
A. Removal of the Smoke Detector
WARNING : DO NOT TRY TO OPEN OR REPAIR THE SMOKE DETECTORS.
_______ THE DETECTOR CONTAINS RADIOACTIVE AMERICIUM 241 OF APPROXIMATELY 0.4 MICROCURIES. ONLY WORKSHOPS AUTHORIZED BY THE MANUFACTURER CAN DO WORK ON THE SMOKE DETECTORS.
NOTE : The removal procedure is the same for all smoke detectors.
____
(1)
Remove the ceiling smoke channels for access to the grid (2).
(2)
Release the quick release fasteners (1).
(3)
Remove the grid (2).
(4)
Disconnect the electrical connector (3) from the smoke detector (6).
R 1EFF : 001-049, 051-061, 101-149, 151-199, 1 26-16-15Page 406 1201-203, 229-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1
Smoke Detectors Figure 401B/TASK 26-16-15-991-001-D
R 1EFF : 106-149, 229-299, 1 26-16-15Page 407 1 1 Aug 01/05 1 1 1CES 1
Smoke Detectors
Figure 401C/TASK 26-16-15-991-001-B
R 1EFF : 151-199, 1 26-16-15 Page 408
1 1 Aug 01/05
1 1
1CES 1
Smoke Detectors
Figure 401D/TASK 26-16-15-991-001-C
R 1EFF : 301-302, 1 26-16-15 Page 409
1 1 Aug 01/05
1 1
1CES 1
R Smoke Detectors
R Figure 401E/TASK 26-16-15-991-001-E
R 1EFF : 303-399, 1 26-16-15 Page 410
1 1 Feb 01/05
1 1
1CES 1
R Smoke Detectors
R Figure 401F/TASK 26-16-15-991-001-F
R 1EFF : 401-499, 1 26-16-15 Page 411
1 1 Aug 01/05
1 1
1CES 1
(5)
Put blanking caps on the disconnected electrical connectors.
(6)
Remove the screws (4) and the washers (5).
(7) Remove the smoke detector (6). R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
Subtask 26-16-15-020-050-A
A. Removal of the Smoke Detector NOTE : The removal procedure is the same for all smoke detectors.
____
(1)
Remove the ceiling smoke channels for access to the grid (2).
(2)
Release the quick release fasteners (1).
(3)
Remove the grid (2).
(4)
Disconnect the electrical connector (3) from the smoke detector (6).
(5)
Put blanking caps on the disconnected electrical connectors.
(6)
Remove the screws (4) and the washers (5).
(7)
Remove the smoke detector (6).
**ON A/C ALL
TASK 26-16-15-400-001 Installation of the Cargo Smoke Detectors
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 26-16-00-710-001 Operational Check of Cargo-Compartment Smoke-Detection by PTT
**ON A/C 001-003,
26-16-15-991-001 Fig. 401 **ON A/C 004-049, 051-099, 101-105, 201-228,
26-16-15-991-001-A Fig. 401A **ON A/C 106-149, 229-299,
26-16-15-991-001-D Fig. 401B **ON A/C 151-199,
26-16-15-991-001-B Fig. 401C
1EFF : ALL 1 26-16-15Page 413 1 1 Aug 01/05R 1 1 1CES 1
-------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
**ON A/C 301-302,
26-16-15-991-001-C Fig. 401D
**ON A/C 303-399,
26-16-15-991-001-E Fig. 401E R **ON A/C 401-499,
R 26-16-15-991-001-F Fig. 401F **ON A/C ALL
3. Job Set-up
__________
Subtask 26-16-15-861-052
A. Make sure the aircraft electrical circuits are energized (Ref. TASK 24-41-00-861-002). 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM FIRE PROTECTION 防火1(86)
