(b)
Put a tag on the sample bottle, write down the location, the date and the time on the tag.
Subtask 38-10-00-614-060
D. Pressurize the potable water system (Ref. TASK 38-10-00-614-001).
4. Procedure
_________ Subtask 38-10-00-281-051
A. Get a Sample of the Potable Water System WARNING : MAKE SURE THAT THE EQUIPMENT YOU USE FOR THIS PROCEDURE IS
_______ CLEAN AND APPROVED FOR THE POTABLE WATER SYSTEM. IF NOT IT CAN CAUSE CONTAMINATION OF THE POTABLE WATER SYSTEM.
NOTE : Only qualified persons should take samples.
____
(1) Let the qualified person get samples from the water faucet at these locations:
-
at a galley,
-
at a lavatory.
NOTE : When the nozzle assy is not installed on the outlet of the
____ water faucet, the water will flow horizontally out of the outlet.
NOTE : You must get the two samples at the farthest point from the
____
potable water tank.
1EFF : ALL 1 38-10-00Page 223 1 1 Feb 01/05R 1 1 1CES 1
(2)
Position the sample bottle in front of the lavatory water-faucet outlet, before you operate the faucet.
(3)
Carefully operate the water faucet for 3 min, then fill the clean BOTTLE - SAMPLE with water.
(4)
Seal the glass sampling bottles.
(5)
Put a tag on the glass sampling bottles.
(6)
Write down the aircraft registration, the system, the Location, the date and the time on the tag.
(7)
Send all the water sample bottles to the hygienic institute for analysis.
Subtask 38-10-00-281-052
B. Water Quality Analysis
Table 1 -------------------------------------------------------------------------------| germs | max. allowed quantity | | | per milliliter / USfl.oz. | |-----------------------------------------------------------------------------| | no. of germs increase at | 1000/1ml | | 20 deg.C (68 deg.F) for 48 hours | 1000/0.034USfl.oz. | |-----------------------------------------------------------------------------| | no. of germs increase at | 100/1ml | | 36 deg.C (96.8 deg.F) for 48 hours | 100/0.034USfl.oz. | -------------------------------------------------------------------------------
Table 2 -------------------------------------------------------------| germ increase rate | |-----------------------------------------------------------| | Echerichia Coli | 0/100ml | | | 0/3.38USfl.oz. | |-----------------------------------------------------------| | Coliform Bacteria | 0/100ml | | | 0/3.38USfl.oz. | -------------------------------------------------------------
NOTE : Tables 1 and 2 show the standards for drinking water, which are
____ approved by AIRBUS INDUSTRIE. It is also permitted to apply the standards which are used by the national authority.
1EFF : ALL 1 38-10-00Page 224 1 1 Feb 01/05R 1 1 1CES 1
(1) If the values of the samples analysis are more than the values given in Table 1 and Table 2 do the sanitization of the potable water system (Ref. TASK 38-10-00-670-002).
Subtask 38-10-00-281-053
R R C. Water Quality Analysis (after disinfection with Hydrogen Peroxide (H2O2) (Herlisil)), (H BIO T50) or (ELSIL)
R R (1) If the values of the microbiological analysis are not within the recommended levels, do the disinfection procedure of the potable water system (with Hydrogen Peroxide (Herlisil)), (H BIO T50) or (ELSIL) again (Ref. TASK 38-10-00-670-002).
(2) Do the flushing of the potable water several times again.
NOTE : This is to make sure that the potable water system is clean.____
5. Close-up________
Subtask 38-10-00-410-063
A. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
Subtask 38-10-00-862-054
B. De-energize the ground service network (Ref. TASK 24-42-00-862-001).
TASK 38-10-00-614-001
Pressurization of the Potable Water System from a Ground Air Supply
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WATER/WASTE 1(25)
