(2)
Put the filter (3) in position.
(3)
Install a new O-ring (2) on the strainer plug (1).
(4)
Install the strainer plug (1) in the waste water drain-assembly.
(5)
Install the stopper (5).
(6)
Make sure that the work area is clean and clear of tool(s) and other items.
Subtask 38-32-00-862-053
B. De-energize the ground service network
(Ref. TASK 24-42-00-862-001).
Subtask 38-32-00-942-051
C. Remove the ground support and maintenance equipment, the special and standard tools and all other items.
R 1EFF : 004-049, 053-099, 101-149, 151-199, 1 38-32-00Page 715 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1 **ON A/C ALL
TASK 38-32-00-100-003
Cleaning of the Sink Drain Valve (Air Stop Valve)
1.
Reason for the Job
__________________
Refer to the MPD TASK: 383200-02
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
the External Power 38-32-41-000-001 Removal of the Drain Valve (Air Stop Valve) 38-32-41-400-001 Installation of the Drain Valve (Air Stop Valve)
R CMM 383002 (for corrective action) R CMM 383025 (for corrective action) CMM 383030 (for corrective action)
3. Job Set-up
__________
Subtask 38-32-00-861-054
A. Energize the aircraft electrical circuits
(Ref. TASK 24-42-00-861-001).
Subtask 38-32-00-010-054
B. Get Access
(1)
Get access to the lavatory.
(2)
Remove the sink drain valve (referred to in this task as the drain valve) (Ref. TASK 38-32-41-000-001).
4. Procedure_________
Subtask 38-32-00-100-050
A. Clean the Drain Valve
R R R R R R (1) Do the cleaning of the drain valve in the shop: - For drain valves with the P/N 9350021 or P/N 9350022 (Ref. CMM 383025) - For drain valves with the P/N ZCV241 (Ref. CMM 383002) - For drain valves with the P/N FRH340003H or P/N FRH340008F (Ref. CMM 383030).
NOTE : Airbus recommends that you do the cleaning and test procedure____ of the drain valve in the shop.
(2) If necessary install the cleaned or a new drain valve (Ref. TASK 38-32-41-400-001).
5. Close-up________
Subtask 38-32-00-410-056
A. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
Subtask 38-32-00-862-054
B. De-energize the aircraft electrical circuits (Ref. TASK 24-42-00-862-001).
Subtask 38-32-00-942-052
C. Put the system back to the serviceable condition.
VALVE - DRAIN - REMOVAL/INSTALLATION
____________________________________
TASK 38-32-41-000-001
Removal of the Drain Valve (Air Stop Valve)
NOTE : The procedure for the removal of all the drain valves is the same.
____
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking plugs
No specific circuit breaker(s) safety clip(s)
No specific container 2.0 l (0.5283 USgal)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power
**ON A/C 001-003, 051-052,
38-32-41-991-001 Fig. 401 R **ON A/C 004-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
38-32-41-991-001-A Fig. 401A **ON A/C ALL
3. Job Set-up
__________ Subtask 38-32-41-861-050
A. Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
**ON A/C 001-049, 051-099, 101-105,
Subtask 38-32-41-865-052
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WATER/WASTE 2(122)
