F 『
E C F M E
E E
E 56-5B E
E E
(9) Ideal Custom Stripmaster wire Stripper:
(Ref. Fig. 003)
(a) The Custom Stripmaster is quite similar to the Stripmaster. The main difference is in the cutting blades. Where Stripmaster has knife type blades, the Custom Stripmaster had die type blades that lend themselves toward stripping harder, slicker, teflon insulation.
3. Quality Assurance
_________________
A. Procedure
The wire stripping operation shall be checked for the following characteristics:
(1) Check compliance with the applicable connector, or termination RPS for the proper strip length. If not available, the stripped wire may be inserted in the solder pot, crimp pot, or crimp barrel of the termination in use, to see if adequate stripped conductor length is extending from the insulation.
(2) Check for compliance with the requirements of these instructions.
(3) Inspect the stripped wire for cut or nicked strands. For the allowable number of cut or nicked strands, see Table 2.
(4) Inspect the wire insulation where the gripper of the stripping tool held the wire during the stripping process. Minor indentation is acceptable. Major indentation and tears in the insulation are cause for rejection.
F 『 EEFF : ALL E Page 1070-71-48
E E Feb 01/01 E E ECES E F 『 E C F M E E E E 56-5B E
Custom Stripmaster
Figure 003
F 『 EEFF : ALL E Page 1170-71-48
E E Feb 01/01 E E ECES E F 『
E C F M E
E E
E 56-5B E
E E R HARNESS OUTER JACKET REPAIR - DESCRIPTION AND OPERATION
_______________________________________________________
R 1. General
_______
R A. The harness outer jacket is installed over the metal overbraid to protect R the overbraid from wear, and to protect the harness from moisture R contamination.
R B. This procedure may be used to perform a temporary, on-wing repair to a R damaged outer jacket.
R NOTE : This procedure is intended as a temporary repair only. A permanent
____ R repair must be incorporated at the next available time period and R location, but not later than the next engine shop visit.
R C. Consumable Materials
R ---------------------------------------------------------------------------R | REFERENCE | DESCRIPTION | SUPPLIER | FSCM | R ---------------------------------------------------------------------------R | CP1041 | Alcohol, Isopropyl | Commercial | | R | | | | | R | HM352 | Tape, insulating, | CHR Industries, Inc. | V71643 | R | | high temperature | An Armco Co. | | R | | | 407 East St. | | R | | | New Haven, CT 06509 | | R | | | | | R | P423 | Tape, insulating, | Permacel Tape Div. | V99742 | R | | high temperature | An Avery Co. | | R | | | U.S. Highway 1 | | R | | | P.O. Box 671 | | R | | | New Brunswick, NJ 08903| | R | | | | | R | 190LOF21G/A | Tape, tying, | Western Filament, Inc. | V00768 | R | MIL-T-43435 | fiberglass | 4680 San Fernando Rd. | | R | Type 4 | | Glendale, CA 91204-1821| | R | | | | | R | 23 X TZ | Tape, tying, | Grudebod, Inc. | V82110 | R | MIL-T-43435 | fiberglass | Griffith Towers | | R | Type 4 | | P.O. Box 357 | | R | | | Pottstown, | | R | | | PA 19464-5568 | | R ---------------------------------------------------------------------------
R 2. Harness Outer Jacket Repair
___________________________ R (Ref. Fig. 001)
F 『 EEFF : ALL E Page 170-71-53
E E Feb 01/03 E E ECES E F 『 E C F M E E E E 56-5B E F 『 EEFF : ALL E Page 370-71-53
R R Harness Outer Jacket Repair Figure 001
F EEFF : E E ECES ALL 『E 70-71-53EEE Page 2 Feb 01/03
F 『
E C F M E
E E
E 56-5B E
E E
R WARNING: ISOPROPYL ALCOHOL IS CLASSIFIED AS A HAZARDOUS MATERIAL WHICH MAY
R CAUSE INJURY OR ILLNESS IF NOT PROPERLY USED. THIS PRODUCT SHOULD BE
R USED ONLY IN ACCORDANCE WITH THE MANUFACTER'S SPECIFIC SAFETY AND
R HEALTH RECOMMENDATIONS. PRIOR TO USE OF THIS PRODUCT, CAREFULLY READ
R THE APPLICABLE ''MATERIAL SAFETY DATA SHEET'' AND OBEY ALL LISTED
R SAFETY AND HEALTH PRECAUTIONS.
R A. Use isopropyl alcohol to clean the harness outer jacket for a distance of
R 3 inches (76.20 mm) on each side of the damage area.
R B. Double Wrap the damage area with high temperature insulation tape.
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM STANDARD PRACTICES - ENGINES(45)
