- the RELAY 8QP, terminal A1 and the RELAY 7QP, terminal B2

 - the RELAY 7QP, terminal X2 and the RELAY 14QP, terminal A

 - the RELAY 8QP, terminal X2 and the RELAY 14QP, terminal B

 - the RELAY 14QP, terminal 1 and the FLSCU-2 rack connector 9QJ-AA, pin 11B

 - the RELAY 14QP, terminal 3 and the FLSCU-1 rack connector 7QJ-AA, pin 11B.

 (b) Repair all the unserviceable wiring and connectors (Ref. ESPM 20-00-00).

 (c) Do the test given in Para. 3.B.(2).

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 216
 201-299, 401-499, Aug 01/05 CES

 TASK 28-15-00-810-806

 Intercell XFR Valve 30QM/73QM/12QP (Right Rear) Fault - Stays Closed When The Fuel In The Inner-cell Is At Low Level
 WARNING : OBEY THE FUEL SAFETY PROCEDURES.
_______
 WARNING : WHEN YOU DO WORK ON THE FUEL SYSTEM WIRING, YOU MUST USE TEST
_______ EQUIPMENT THAT IS APPROVED (REFER TO INTERNATIONAL OR NATIONAL SPECIFICATIONS FOR INTRINSICALLY SAFE TEST EQUIPMENT, E.G. EN50-020, UL913 OR EQUIVALENT). TEST EQUIPMENT THAT IS NOT APPROVED CAN CAUSE FIRE OR AN EXPLOSION.
 1. Possible Causes
_______________
 - ACTUATOR-TRANSFER VALVE, R REAR SPAR (12QP)

 - aircraft wiring

 - RELAY-R WING TK LOW LEVEL CHANNEL B (6QP)

 - RELAY-L WING TK LOW LEVEL CHANNEL A (5QP)

 - RELAY-L OR R REAR XFR VALVE OPEN LATCH (13QP)

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific multimeter
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
ESPM 20-00-00 AMM 28-15-00-740-002 Functional (BITE) Test of the Intercell Transfer
 Valves AMM 28-15-51-000-002 Removal of the Actuator 11QP(12QP) AMM 28-15-51-400-002 Installation of the Actuator 11QP(12QP) AMM 28-46-00-740-001 Functional (BITE) Test ASM 28-15/01
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 217
 201-299, 401-499, Aug 01/05 CES

 3. Fault Confirmation
__________________

 A. Table of the circuit breakers used in this procedure:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FUEL/FQI/CHAN/1 1QT A13 49VU FUEL/XFR VALVE1/WING/R 2QP A11 49VU FUEL/XFR VALVE1/WING/L 1QP A10
 121VU FUEL/FQI/CHAN/2 2QT M27
 B. Test
 (1) Do the Functional BITE Test (of the FLSS) (Ref. AMM TASK 28-46-00-740-001).

 (a) Examine the FLSS STATUS page. Look for one (or more) of the messages that follow:

 - L LO LEVEL SENSOR 16QJ1

 - R LO LEVEL SENSOR 15QJ2

 - FLSCU1 7QJ

 - FLSCU2 9QJ.

 (b) If a message(s) listed (in the step before):

 - is not shown, do step (2)

 - is shown, trouble shoot the LRU(s) before you do step (2). Refer to the Fault Symptoms List/28-CFDS for the related Task number.

 (2) Do the Functional BITE Test of the Intercell Transfer Valves (Ref. AMM TASK 28-15-00-740-002).

 NOTE : The COMMAND FLSS BITE option does not test the Intercell
____
 Transfer Valves (ICTVs).

 NOTE : The ICTVs are motor driven and the electrical power for these
____ circuits is supplied from 801PP, 28VDC, ESS BUS/SHEDDABLE (Ref. ASM 28-15/01). The ICTVs will not operate on battery power.
 (a) Examine the FLSS STATUS page. Look for the (right wing rear ICTV) message XFR VALVE 30QM/73QM/12QP.

 (b) If the message:

 - is shown, do Para. 4.A.

 - is not shown, no work steps are necessary.

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 218
 201-299, 401-499, Aug 01/05 CES
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 FUEL 燃油1(27)