- the message LO AIR PRESS on the lower ECAM DU,
- the BLUE ELEC PUMP P/BSW FAULT light on panel 40VU,
- do a visual check of the pressure shown on the gage of the Blue reservoir.
(1) If the pressure is more than 25 psi (1.7236 bar):
- do a check of the wiring between: PRESS SW-B RSVR AIR (2384GH) connector A/A and PRESS SW-B RSVR AIR (2384GH) connector A/C (Ref. ASM 29-12/01).
(a) If there is continuity:
- replace the PRESS SW-B RSVR AIR (2384GH) (Ref. AMM TASK 29-34-11-000-002) (Ref. AMM TASK 29-34-11-400-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞29-12-00∞∞∞∞∞∞∞∞∞∞Page 207
Aug 01/05 CES
(b) If there is no continuity:
- make sure that the wiring is not connected to GND between: PRESS SW-B RSVR AIR (2384GH) connector A/C and DIODE (1156VD) connector 5. (Ref. ASM 29-12/01).
1 If the wiring is connected to the GND:
_ - repair the wiring.
(2) If the pressure shown on the gage of the Blue reservoir is less than 25 psi (1.7236 bar):
- do a check of the clogging indicator on the Reservoir Pressurization Unit (1360GM).
(a) If the clogging indicator is out:
- replace the filter element (Ref. AMM TASK 29-14-41-610-002).
(b) If the clogging indicator is not out, or the fault continues after replacement of the filter element:
- pressurize the hydraulic reservoirs with a ground cart (Ref. AMM TASK 29-14-00-614-002),
- do a check of the pressure drop on the gage of the hydraulic reservoir.
NOTE : No pressure drop is permitted within 15 minutes at a gage
____ pressure of 50 psi (3.4473 bar)
1 If the air pressure drop is out of limits:
_
- do a check of the VALVE-MAN DEPRESS, B RSVR (2087GM) for leaks.
a If the VALVE-MAN DEPRESS, B RSVR (2087GM) has a leak:
_
- replace the VALVE-MAN DEPRESS, B RSVR (2087GM) (Ref. AMM TASK 29-14-16-000-002) and (Ref. AMM TASK 29-14-16-400-002).
b If the VALVE-MAN DEPRESS, B RSVR (2087GM) has no leak:
_
- do a check of the VALVE-AIR RELIEF, B RSVR (2005GM) for leaks.
- If the VALVE-AIR RELIEF, B RSVR (2005GM) has a leak:
- replace the VALVE-AIR RELIEF, B RSVR (2005GM) (Ref. AMM TASK 29-14-17-000-001) and (Ref. AMM TASK 29-14-17-400-001).
- If the VALVE-AIR RELIEF, B RSVR (2005GM) has no leak:
- do a check of the PRESS GAGE-B RSVR (2383GM) for leaks.
- If the PRESS GAGE-B RSVR (2383GM) has a leak:
- replace the PRESS GAGE-B RSVR (2383GM) (Ref. AMM TASK 29-14-15-000-002) and (Ref. AMM TASK 29-14-15-400-002).
- If the PRESS GAGE-B RSVR (2383GM) has no leak:
- do a check of all connections and components on the reservoir for leaks.
- If you find a leak:
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 062-099, 106-149, 151-199, 204-299, ∞∞29-12-00∞∞∞∞∞∞∞∞∞∞Page 208
301-399, 401-499, Aug 01/05 CES
2
_
- tighten the related nut or replace the defective component.
c If the fault continues:
_
- replace the CHECK VALVE-RSVR PRESS, B (2388GM).
If the air pressure drop is in the limits:
a Depressurize the hydraulic reservoirs (Ref. AMM TASK 29-14-
_ 00-614-001).
b Pressurize the reservoir pressurization system with the
_ left engine (Ref. AMM TASK 29-14-00-720-002), or
c Connect an external pressure source:
_
- disconnect the reservoir pressurization hose (1674GM) from the HP bleed-air port of the left engine (Ref. AMM TASK 29-14-49-000-001)
- connect an approved air or nitrogen inflation adaptor to the line end fitting of the reservoir pressurization hose (1674GM)
- pressurize the reservoir pressurization system to
approximately 15.2 bar (220 psi).
d If the pressure in the reservoir does not increase to the
_ necessary value:
- remove the RESTRICTOR- RSVR PRESS, ENG 1 BLEED (1392GM) (Ref. AMM TASK 29-14-13-000-001).
- make sure that the RESTRICTOR- RSVR PRESS, ENG 1 BLEED (1392GM) and the filter are not clogged or damaged.
- if necessary, replace the RESTRICTOR- RSVR PRESS, ENG 1 BLEED (1392GM) (Ref. AMM TASK 29-14-13-400-001). 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 液壓(38)
