-
ENG 2 R IGN

 -
ENG 2 L IGN

 D. Do a test the control module installation.
 S 714-012
 (1)  Do the test on the engine and APU fire control module (Ref 26-21-51/501).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-21-51
 ALL  ú ú 01 Page 402 ú Jul 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 864-013
 (2)  Remove the electrical power if it is not necessary (Ref 24-22-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-21-51
 ALL  ú ú 01 Page 403 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 ENGINE AND APU FIRE CONTROL MODULE - ADJUSTMENT/TEST
____________________________________________________
 TASK 26-21-51-725-180
 1.  Engine and APU Fire Control Module Functional Test__________________________________________________
 A. General
 CAUTION:_______DO NOT START AN ENGINE SHUTDOWN WITH THE FIRE SWITCH. AN ENGINE SHUTDOWN BY MEANS OF THE FIRE SWITCH IS NOT A RECOMMENDED TEST PROCEDURE AND CAN CAUSE DAMAGE TO EQUIPMENT.
 (1)  
The engine and APU fire control module P8-1 contains components to monitor the fire and overheat detection systems and to control and test the fire extinguishing system. This procedure supplies a functional check of the engine and APU fire control module (P8-1) on the control stand.

 (2)  
The tests that follow are contained in the functional test:

 (a)  
Engine and APU Fire Control Module Test

 (b)  
Fire Switch Handle Test

 (c)  
Pressure Switch Circuits

 (d)  
Engine and APU Squib Circuits

 (e)  
Bottle squib connections

 (3)  
The front of the module contains these components for extinguishing and detection:

 (a)  
fire switch handles with fire warning lights for each engine and the APU,

 (b)  
discharge lights for each engine and APU,

 (c)  
overheat lights for each engine,

 (d)  
engine detector fault light,

 (e)  
fire/overheat detector selector switch for each engine,

 (f)  
an APU detector inoperative light,

 (g)  
a bell cutout switch,

 (h)  
test switches,

 (i)  
three fire extinguisher test lights.

 (4)  
The control circuits for the master caution lights and the test circuits for the fire extinguisher bottle are on cards in the module.

 B. Equipment
 (1)  28 Volt test lamp (Quantity: 2)
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-21-51
 ALL  ú ú 01 Page 501 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 C.
D.
E.
A
737-300/400/500MAINTENANCE MANUAL
 (2)
Multimeter 0-1000 vdc with a 10 kohm resistor installed across the

 leads (alternate to 28 Volt test lamp) (Quantity: 2)References

 (1)
AMM 24-22-00/201, Manual ControlAccess

 (1)
Location Zone

 101, 102 Control CabinPrepare for the Test
 S 865-002
 (1)
Supply electrical power (AMM 24-22-00/201).

 S 865-003

 (2)
Open these circuit breakers on the P6-2 panel.

 (a)
EXTINGUISHER BOTTLES RIGHT

 (b)
EXTINGUISHER BOTTLES LEFT

 (c)
EXTINGUISHER BOTTLE RIGHT

 (d)
EXTINGUISHER BOTTLE LEFT

 (e)
EXTINGUISHER BOTTLES APU

 S 865-005
 (3) Disconnect these electrical connectors in the main wheel well:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 防火 FIRE PROTECTION(104)