STEERING CYLINDER YOKE BUSHING STEERING
ZERK
CYLINDER
1
BMS 3-33 2
1 (4 LOCATIONS) (4 LOCATIONS)
1
APEX
YOKE BUSHING ZERK
BMS 3-33 SHOCK SPINDLE
STRUT
2 (1 LOCATION) ACTUATOR(4 LOCATIONS) ZERK
30 POINTS
BMS 3-33
D (1 LOCATION)
1 ONE MORE LUBE POINT IS ON THE OPPOSITE SIDE (NOT SHOWN). ACTUATOR
2 BUSHINGS WITH PAINTED WITNESS LINE ACTUATOR
(OR EQUIVALENT IDENTIFICATION MARK), ZERK DO THESE STEPS: . LUBRICATE THE JOINT
BMS 3-33 . APPLY BMS 3-23 OR BMS 3-26 COMPOUND, POINT THE SPRAY AROUND (2 LOCATIONS) THE BUSHING FLANGE BETWEEN THE BUSHING AND THE MATING LUG SURFACE. . LUBRICATE THE JOINT AGAIN TO REMOVE ACTUATOR ALL COMPOUND FROM THE JOINT
WHEEL TRUCKZERK
3
THE LEFT LANDING GEAR IS SHOWN.
4 POINTS
BMS 3-33 FITTINGS ON THE BOTTOM OF THE YOKE.
THE RIGHT LANDING GEAR HAS THE (1 LOCATION)
E
4
THIS IS A GROUP OF FIVE FITTINGS
Body Landing Gear Lower End Lubrication
Figure 308 (Sheet 3)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-21-01
ALL ú ú 01 Page 323 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
(2 LOCATIONS)
5
BUSHING AND THE MATING LUG SURFACE.
3 POINTS
. LUBRICATE THE JOINT AGAIN TO REMOVE
ALL COMPOUND FROM THE JOINT
G
5
THE LEFT LANDING GEAR IS SHOWN.
THE RIGHT LANDING GEAR HAS THE
FITTINGS ON THE TOP OF THE
TORSION LINK
Body Landing Gear Lower End Lubrication Figure 308 (Sheet 4)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-21-01
ALL ú
ú 01 Page 324
ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
SHOCK STRUT INNER CYLINDER
PIVOT PIN ZERK
(4 LOCATIONS) ROYCO 11MS 1
BRAKE ROD ZERK 1
(6 LOCATIONS) BMS 3-33 6 BUSHING BRAKE ROD 1 PIVOT PIN BUSHING 1 BUSHING PIVOT PIN
2 (4 LOCATIONS) 2 (2 LOCATIONS) 2 (2 LOCATIONS)
6 2 1 . APPLY BMS 3-23 OR BMS 3-26 ALL COMPOUND FROM THE JOINT THE BUSHING FLANGE BETWEEN THE . LUBRICATE THE JOINT . LUBRICATE THE JOINT AGAIN TO REMOVE COMPOUND, POINT THE SPRAY AROUND BUSHING AND THE MATING LUG SURFACE. OPPOSITE SIDE (NOT SHOWN). ONE MORE LUBE POINT ON OTHER SIDE OF OPPOSITE SIDE (NOT SHOWN). ONE MORE LUBE POINT IS ON THE BRAKE ROD. TWO MORE LOCATIONS ON (OR EQUIVALENT IDENTIFICATION MARK), BUSHINGS WITH PAINTED WITNESS LINE DO THESE STEPS: 18 POINTS H
Body Landing Gear Lower End Lubrication Figure 308 (Sheet 5)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-21-01
ALL ú ú 01 Page 325 ú Feb 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
BRAKE ROD ZERK
BMS 3-33 (1 LOCATION)
3 POINTS
I7 NOTE: THIS FIGURE SHOWS THE BRAKE WITHOUT THE WHEEL AND AXLE. IT IS NOT NECESSARY TO REMOVE PARTS TO LUBRICATE THE BRAKE.
7 EACH LANDING GEAR HAS FOUR BRAKES. LUBRICATE EACH BRAKE AS IT IS SHOWN
8 LUBRICATE THROUGH THE GREASE FITTING WITH A SMALL QUANTITY OF GREASE.
TOO MUCH LUBRICATION CAN CAUSE A FIRE DURING OPERATION.
9 DO NOT CONTAMINATE WITH OTHER GREASES.
Body Landing Gear Lower End Lubrication
Figure 308 (Sheet 6)
BRAKE CARRIER ZERK
AEROSHELL 22 (1 LOCATION) 89
BRAKE HOUSING ZERK
ROYCO 11MS (1 LOCATION)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-21-01
ALL ú ú 01 Page 326 ú Feb 18/01
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 SERVICING 2(13)
