54-53-00
 ALL  ú ú 01N Page 214 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 012-097
 WARNING: OBEY THE INSTRUCTIONS IN THE PROCEDURE TO OPEN THE THRUST
_______ REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (4)  Open the left and right thrust reversers (AMM 78-31-00/201).
 S 042-099
 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF THE LE AND TE
_______ FLAPS AND FLAP DRIVE MECHANISMS BEFORE YOU MOVE THE FLAP CONTROL LEVER. WITH HYDRAULIC POWER REMOVED, THE FLAPS WILL MOVE AUTOMATICALLY BY ELECTRICAL POWER WHEN YOU MOVE THE FLAP CONTROL LEVER. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE LE FLAP SAFETY LOCKS. THE LE FLAPS CAN MOVE QUICKLY IF YOU DO NOT INSTALL THE SAFETY LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (5)  
Do this task: "Extended Leading Edge Flaps Deactivation and Safety Locks Installation" (AMM 27-81-00/201).

 S 012-100

 (6)  
Remove these access panels (AMM 54-62-00/201):

 (a)  
Access panel 452AL/482AL on the left side of the strut at NSTA 164.

 (b)  
Access panel 452EL/482EL on the left side of the strut at NSTA 217.

 (c)  
Access panel 452CL/482CL on the left side of the strut at NSTA 186.

 S 582-101
 (7)  Level the airplane to a minimum of one-half degree (AMM 08-00-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-53-00
 ALL  ú ú 01N Page 215 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 162-102
 CAUTION:_______MAKE SURE YOU KEEP THE STRUT AREA CLEAN. TOOLS, LOOSE AND UNWANTED MATERIALS IN THE STRUT COMPARTMENTS CAN BLOCK THE REMOVAL OF THE FLUIDS THROUGH THE STRUT DRAINS. IF YOU DO NOT REMOVE THE UNWANTED MATERIALS, YOU CAN CAUSE DAMAGE TO THE STRUT.
 (8)  
Make sure you remove all unwanted materials (spilled sealant, fasteners, tie wires, etc.) from the midspar upper surface and the midspar forward drain inlet (NSTA 212).

 S 032-103

 (9)  
Disconnect the raceway drain fitting form the drain line just below the raceway.

 (a) Install a cap or plug into the raceway drain fitting.
 F. Do Leak Check S1 - Outboard (Figs. 201 and 202)
 S 942-104
 (1)  
Put an empty container below the strut forward drain outlet
 (NSTA 154).

 S 792-105

 (2)  
With a funnel and hose, apply water over the top surface of the midspar, through access door 452EL/482EL at NSTA 217 as follows:

 (a)  Apply 254 to 258 fluid ounces (7510 to 7630 ml) of water in 3.5 to 4.5 minutes.
 NOTE: This is approximately 64 fluid ounces (1/2 gallon or
____ 1900 ml) per minute for 4 minutes.
 (b)  Make sure you completely wet the midspar upper surface and all the system penetrations into the midspar forward cavity.
 S 792-106
 (3)  Look for leaks as follows:
 (a)  
Make sure you see no water leaks at the midspar lower surface.

 (b)  
Make sure there is no water leakage from the left and right dry bay condensate drain tubes.

 (c)  
Make sure there is no water leakage near the midspar forward drain fitting.

 S 792-107
 (4)  After three minutes, make sure that a minimum of 236 fluid ounces (6980 ml) of water has collected in the container.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-53-00
 ALL  ú ú 01N Page 216 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 792-108
 (5)  Look for leaks from the raceway drain as follows:
 (a)  
Put a small empty container below the raceway drain fitting.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 NACELLES/PYLONS(59)