曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 NOTE:____ Smooth the 3M No. 471 yellow vinyl adhesive tape on the airplane surface to make sure the bond is satisfactory.
 (c) (d) (e)  1) Do not put vinyl adhesive tape over the holes of the static ports.Put an 8-inch strip of 3M No. 471 yellow vinyl adhesive tape on each vertical edge of the barricade tape overlapping the first strip of adhesive tape (see Fig. 302, Sheet 2, Step 3).Put an 8-inch strip of 3M No. 471 yellow vinyl adhesive tape below the lower primary static port holes overlapping the two vertical strips of adhesive tape (see Fig. 302 Sheet 2, Step 4).The barricade tape should be allowed to stream down so it is visible from the ground.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-25-01
 ALL  ú ú 01.1 Page 307 ú Sep 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 843-030
 (9)  
Attach a red paper tag that has "STATIC PORTS COVERED" printed on it in black letters, to the top of the left control wheel in the flight deck with wire.

 S 843-047

 (10)
 Use plastic membranes to cover the components in Table 304.  All components are identified in Fig. 303 thru Fig. 317.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-25-01
 ALL  ú ú 01 Page 308 ú Sep 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 ~.............................................................................. | TABLE 304 | ................................................................................ | |Location|Figure|Sheet| | Item Description | |Number| | ................................................................................ |Hydraulics: Flight Controls, Locations | -| 303 | 1 | ................................................................................ | Aileron PCUs | 1 | 303 | 2,3 | ................................................................................ | Outboard Spoiler PCUs | 2 | 303 | 4,5 | ................................................................................ | Inboard Spoiler PCUs | 3 | 303 | 4,5 | ................................................................................ | Lateral Autopilot Actuator | 4 | 303 | 6 | ................................................................................ |High Lift Components: | | | | ................................................................................ | Power Drive Unit - TE Flap: | | | | ................................................................................ | Hydraulic Motor | 6 | 304 | 1 | ................................................................................ | Torque Tube | 7 | 304 | 1 | ................................................................................ | Alternate Electric Motor | 8 | 304 | 1 | ................................................................................ | Control Valve Assembly | 9 | 304 | 1 | ................................................................................ | Bypass Valve | 10 | 304 | 2 | ................................................................................ | Position Transmitter | 11 | 304 | 2 | ................................................................................ | TE Flap Control Valve | 5 | 304 | 3 | ................................................................................ | No. 1 & 8 TE Angle Tee Gearbox Assembly: | 12 | 305 | | ................................................................................ | No. 2 & 7 TE Angle Tee Gearbox Assembly | 13 | 305 | | ................................................................................ | Bearing Assembly - TE Flap Drive Torque Support | 14 | 306 | | ................................................................................ | Bearing Assembly - TE Flap Drive Torque Support | 15 | 306 | | ................................................................................ | Bearing Assembly - TE Flap Drive Torque Support | 16 | 306 | | ................................................................................ | Bearing Assembly - TE Flap Drive Torque Support | 17 | 306 | | ................................................................................ | No. 3 & 6 TE Tee Gearbox Assembly | 18 | 307 | | ................................................................................ | No. 3 & 6 TE Angle Gearbox Assembly | 19 | 308 | |
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 SERVICING 2(70)