曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

____ is necessary. If the first fillet seal is fully cured but is not clean, then it must be cleaned before you apply the second fillet seal. Do not use different sealants for the first fillet and the second fillet.
 1) If you use an extruded nozzle, do the steps that follow: a) Cut the nozzle to make a fit of the dimensions shown in Fig. 808.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ALL  ú ú 01 Page 820 ú Sep 28/01

A

757 MAINTENANCE MANUAL
 b)  Push the nozzle head against the surfaces such that the fillet seal you apply is thickest in the middle of the surfaces.
 NOTE: Keep the nozzle of the sealing gun near the
____ surface to prevent air bubbles.
 2)  If you do not use an extruded nozzle, use a sealant fairing tool to make a full bodied fillet seal.
 3)  Remove all air bubbles and re-entrant fillet seal edges.
 (g)  If it is necessary, do this Task: Application of Corrosion Resistant Finish (Topcoat) (AMM 28-11-00/701).
 NOTE: A layer of corrosion resistant finish is necessary
____ only to protect bare (anodized) metal. It is not necessary to apply a layer of corrosion resistant finish on sealant. Corrosion resistant finish can be applied on sealant, but it is not necessary. Usually topcoat is applied to sealant only when it must be applied to protect adjacent bare metal.
CLASS A-2

Apply the Precoat
Figure 805

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ALL  ú ú 01 Page 821 ú Sep 20/96

C76314
A

757
MAINTENANCE MANUAL

SEALING GUN

Apply a Fillet Seal
Figure 806

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ALL  ú ú 01 Page 822 ú Mar 20/94

A

757
MAINTENANCE MANUAL

Push the First Fillet Seal into the Seam
Figure 807

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 燃油 CHAPTER 28 - FUEL 1(127)