(a)
Filter module for the pressure and case drain of the alternating current motor pump (ACMP), referred to in this procedure as the filter module
(b)
Filter elements
(c)
Differential pressure indicators
(d)
Check valves
(e)
Pressure switch.
(2)
To start one of these procedures, do the "Prepare for Removal" group of steps. Then, do the applicable group of steps that is necessary to remove the component.
B. References
(1)
AMM 29-11-00/201, Main (Left, Right, and Center) Hydraulic Systems
(2)
AMM 32-00-15/201, Main Gear Door Locks
(3)
AMM 32-00-20/201, Landing Gear Downlocks
C. Access
(1) Location Zones
143/144 MLG Wheel Well
D. Prepare for Removal
S 494-002
(1) Make sure the downlocks are installed on the nose and main landing gear (AMM 32-00-20/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
29-11-18
ALL ú ú 01 Page 401 ú Sep 28/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
S 494-003
WARNING: DO THE PROCEDURE IN AMM 32-00-15/201 TO INSTALL THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Open the doors for the landing gear and install the door locks (AMM 32-00-15/201).
S 864-004
(3)
Open these circuit breakers on the overhead panel, P11, and attach DO-NOT-CLOSE tags:
(a)
11K16, HYDRAULICS ELEC PUMP RIGHT
(b)
11K25, HYDRAULICS ELEC PUMP LEFT
S 864-005
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 液壓 CHAPTER 29 - HYDRAULIC POWER 1(217)
