曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Enunciation:  “PROGRAM PIN PARITY ERROR” (MK V or MK VII only) 
Probable Cause:  Wiring error in the program pins. 
Action:  Verify wiring to each program pin.  Verify ODD parity selected. 
Enunciation:  “AIRCRAFT TYPE INVALID” (MK V or MK VII only) 
Probable Cause:  Wiring error to the Aircraft Type program pins. 
Action:  Verify wiring to the Aircraft Type program pins. 
Enunciation:  “CONFIGURATION TYPE INVALID” (MK VI or MK VIII only) 
Probable Cause:  The programmed configuration type is not a valid configuration. 
Action:  Correct and reprogram the Configuration Module (see Maintenance Practices section) 
Enunciation:  “AIRCRAFT CONFIGURATION DATA BASE FAILED” (MK V or MK VII only) 
Probable Cause:  EGPWC internal Configuration database error. 
Action:  Pull power to the EGPWS for one minute and cycle power to clear all potential faults before removing  or replacing the EGPWC for repair (see Removal/Installation section) 
Enunciation:  “ APPLICATION DATA BASE FAILED” (MK VI or MK VIII only) 
Probable Cause:  EGPWC internal Application database error. 
Action:  Pull power to the EGPWS for one minute and cycle power to clear all potential faults before removing  or replacing the EGPWC for repair (see Removal/Installation section) 
Enunciation:  “AIRCRAFT CONFIGURATION DATA BASE CRC FAILED” (MK V or MK VII only) 
Probable Cause:  EGPWC internal configuration database error. 
Action:  Pull power to the EGPWS for one minute and cycle power to clear all potential faults before removing  or replacing the EGPWC for repair (see Removal/Installation section) 
Enunciation:  “ APPLICATION DATA BASE CRC FAILED” (MK VI or MK VIII only) 
Probable Cause:  EGPWC internal Application database error. 
Action:  Pull power to the EGPWS for one minute and cycle power to clear all potential faults before removing  or replacing the EGPWC for repair (see Removal/Installation section) 
Enunciation:  “CONFIGURATION MODULE READ ERROR” (MK VI or MK VIII only) 
Probable Cause:  The Configuration Module is faulty. 
Action:  Verify Configuration Module connections.  Cycle power to the EGPWC.  If the problem persists, reprogram the Configuration Module.  IF the condition persist, replace the Configuration Module.  See Removal/Installation section. 

POSSIBLE SELF-TEST PREAMBLE RESULTS 
Enunciation:  “CONFIGURATION MODULE NOT PROGRAMMED” (MK VI or MK VIII only) 
Probable Cause:  The Configuration Module is not programmed. 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：增強型近地警告系統 Enhanced Ground Proximity Warning 航線維護手冊 Systems Line Maintenance Manual(22)