3.8.7 SELF-TEST DISCRETE
Type: Supplied by momentary actuated cockpit self-test switch Signal Status: Self-Test or Normal Fault monitoring: Activation of this input continuously for more than 60 seconds will result in the "Self-Test Invalid”
fault which will cause a GPWS INOP indication. Note: This input is used to start and stop the Level 6 Self-Test, there is no audio output for this discrete in Level 6.

3.8.8     DISCRETES
To activate Steep Approach, both of the Steep Approach discretes must be selected. Discrete #1 should be enabled if Steep Approach is to be used, and can be permanently enabled.  Discrete #2 should be selected in flight when starting a steep approach, it should not be permanently selected. On ground Self-Test is inhibited if Steep Approach is active.
3.8.8.1 STEEP APPROACH DISCRETE #1 (MK V AND MK VII ONLY)
Type: Steep Approach Enabled
Signal Status: Steep Approach Enabled or Disabled
Level 6 Audio readout Enabled => “Steep Approach Enabled” Steep Approach Discrete #1 Disabled => “Steep Approach Disabled”

3.8.8.2 STEEP APPROACH DISCRETE #2
Type: Steep Approach Selected Signal Status: Steep Approach Selected or Not Selected
Level 6 Audio readout Selected => “Steep Approach Selected” Steep Approach Discrete #2
Not Selected =>  “Steep Approach Not Selected”

3.8.9 GND ILS TUNED DISCRETE
Type: Supplied by ILS/VOR Mode Selector. Signal Status: ILS tuned or VOR tuned
Level 6  Audio readout 
GND ILS Tuned Discrete #1  ILS Tuned => ILS Not Tuned =>  “ILS 1 Tuned” “ILS 1 Not Tuned” 
GND ILS Tuned Discrete #2  ILS Tuned => ILS Not Tuned =>  “ILS 2 Tuned” “ILS 2 Not Tuned” 

3.8.10 +28V ILS TUNED DISCRETE
Type: Supplied by ILS/VOR Mode Selector. Signal Status: ILS tuned or VOR tuned
Level 6  Audio readout 
+28 V ILS Tuned Discrete #1  ILS Tuned => ILS Not Tuned =>  “28V ILS 1 Tuned” “28V ILS 1 Not Tuned” 
+28 V ILS Tuned Discrete #2  ILS Tuned => ILS Not Tuned =>  “28V ILS 2 Tuned” “28V ILS 2 Not Tuned” 

3.8.11 GLIDESLOPE VALIDITY DISCRETES
Two Glideslope Validity Discretes may be used by EGPWS, one for each possible ARINC 547 Glideslope Receiver
input.
Type: Validity from ARINC 547 Glideslope receiver.
Signal Status: Valid or Invalid

Level 6  Audio readout 
Glideslope Validity Discrete #1  Valid => Invalid =>  “Glideslope 1 Valid” “Glideslope 1 Invalid” 
Glideslope Validity Discrete #2  Valid => Invalid =>  “Glideslope 2 Valid” “Glideslope 2 Invalid” 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：增強型近地警告系統 Enhanced Ground Proximity Warning 航線維護手冊 Systems Line Maintenance Manual(35)