曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

2. With one computer inoperative, test the operative computer as follows:
 Set parking brake ON in order to enable the EICAS test function.
 Set computer select switch to operative computer. Press TEST switch on maintenance panel, P61, checking for TEST OK message on EICAS(all versions prior to 1001; 1001 EICAS messages are: NO INTERFACE FAULTS, NO INTERNAL FAULTS, and, SELF TEST COMPLETE).
3. Open and collar the circuit breaker for the affected unit (CRT or computer) as follows:
 Inoperative CRT - EICAS UPPER DSPL or EICAS LOWER DSPL (P11 panel)
 Inoperative computer - L (or R) EICAS COMPUTER (P11 panel)
4. Prior to each departure, perform the CARGO FIRE/OVHT TEST by pressing the ENG/APU/CARGO FIRE/OVERHEAT TEST SWITCH.
OPERATIONS (O)
1. For an EICAS computer inoperative, before takeoff, with engines running, compare engine display on EICAS with the Standby Engine Instrument. The EICAS/SEI engine display cross-compare tolerances are as follows:
Engine Display EICAS/SEI Engine Display
Cross-Compare Tolerance
EPR .01
EGT 12.0°C
N1 .2%
N2 1.0%
 
 Power setting for Takeoff must be made with EICAS.
 If remaining EICAS fails:
 Use SEI to observe engine parameters.
 Prior to descent, scan overhead panel for possible non-normal indications.
 
  B757 - 200 MINIMUM EQUIPMENT LIST

EICAS STATUS MESSAGES
None
PLACARD
As appropriate
 
 
B757 - 200 MINIMUM EQUIPMENT LIST

 

 
Dispatch with inoperative (nuisance) Status level messages is allowed by the provisions of this MEL item. EICAS nuisance messages are discussed in Boeing Service Letters 31-012 and 31-013 for Pratt & Whitney and Rolls Royce engines, respectively.
An inoperative message is one which is displayed when there is no actual equipment fault. If such an EICAS
message is suspected, dispatch may still be accomplished by verifying that the equipment associated with the inoperative EICAS status message operates normally (proviso a); or, if MEL relief is available, by observing the MEL remarks or exceptions for the associated inoperative equipment (proviso b). The EICAS Cross Reference List (Section 1) can be used to locate the appropriate item for possible MEL relief.
Maintenance (M) procedures are presented herein to verify normal operation of equipment for selected nuisance status messages. The message list that follows is not intended to be all inclusive:
EICAS STATUS MESSAGES
L(R) OIL SCAV VAL (P&W ONLY) FUEL QTY CHANNEL
POWER XFER UNIT
PLACARD
As appropriate
MAINTENANCE (M)
1. L (R) OIL SCAV VAL
The following procedure can be used to verify normal operation of the #4 bearing scavenge valve for P&W engines when the Status message L(R) OIL SCAV VAL is displayed.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 最低設備清單 Minimum Equipment List (MEL) 2(30)