NOTE: MEL Item 32-42-1 applies to all Normal and Alternate Antiskid System faults (including transducer faults) except for Alternate Antiskid Valve faults. For Alternate Antiskid Valve faults, consult MEL item 32-42-2 for possible dispatch relief.
EICAS STATUS MESSAGES
NORM ANTISKID
PLACARD
Airplane flight log (two or more channels inoperative) - ANTISKID INOP
Autobrakes switch as appropriate - AUTO BRAKES INOP
Airplane flight log as appropriate - ONE BRAKE INOP - DEACTIVATION TOOL INSTALLED Airplane flight log as appropriate -ONE BRAKE INOP - BRAKE LINE CAPPED MAINTENANCE (M)
 For dispatch with one antiskid channel inoperative, deactivate the associated brake in accordance with Item 32-41-1.
 For antiskid system inoperative dispatch with two or more channels inoperative, it is recommended that the inoperative channels be deactivated and the remaining operating channels be used. Deactivate inoperative antiskid channels using either procedure A or B below (operative channels remain available) or deactivate the entire system per step 3. Procedure A is applicable only for airplanes with an Antiskid ON/OFF switch on the P5 panel.
A. Deactivate the inoperative channels using EICAS antiskid advisory messages.
 
 With electrical power on the airplane, open the four antiskid circuit breakers (ANTISKID 1- 5, ANTISKID 2-6, ANTISKID 3-7 and ANTISKID 4-8; P11 panel). EICAS message ANTISKID OFF should appear.
 One at a time, close each circuit breaker. If advisory message ANTISKID OFF remains with circuit breaker closed, that channel of the antiskid system is faulty. Open and collar the circuit breaker. If advisory message ANTISKID OFF is no longer displayed and advisory message ANTISKID displays, that channel is operative. Re-open the operative channel circuit breaker prior to checking other channels.
 After all four pairs of channels have been checked, close circuit breaker(s) for all operative channels.
 Placard flight log and - ANTISKID INOP.
 Select AUTO BRAKES OFF and placard switch - AUTO BRAKES INOP. B. Deactivate the inoperative channels using BITE check:
 Gain access to antiskid box, main E/E equipment center.
 Note all faults by pressing BIT until TEST END.
 Clear faults by pushing RESET.
 Note recurrent faults by pressing BIT until TEST END.
 Open and collar circuit breakers for channels that display fault codes XDCR ____ or BOX ____.
FAULT CODES CIRCUIT BREAKer
 
XDCR1 XDCR5 BOX 1-5 ANTISKID 1-5
XDCR2 XDCR6 BOX 2-6 ANTISKID 2-6
XDCR3 XDCR7 BOX 3-7 ANTISKID 3-7
XDCR4 XDCR8 BOX 4-8 ANTISKID 4-8

 Placard flight log (and antiskid switch if installed) - ANTISKID INOP.
 Select AUTO BRAKES OFF and placard switch - AUTO BRAKES INOP. 3. For dispatch with all antiskid system channels inoperative, deactivate the system as follows:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 最低設備清單 Minimum Equipment List (MEL) 2(40)