3) Use a heat gun at 180o F to warm up decorative laminates to weaken adhesive.
4) Starting in one corner, peel decorative away from the surface.
5) When all decorative is removed, remove remains of adhesive with Rho-clean
solvent.
B. Cleaning of surfaces prior to installing Decorative Material
1) Dampen a cloth with solvent, Rho-clean, and wipe surface clean.
2) Use a clean dry cloth to dry the surface.
Caution: Do Not Allow The Solvent To Evaporate To Dryness. 3) Repeat the above procedures, until there is no color transfer on a clean, dry cloth. Do not touch the cleaned surfaces with bare hands.
C. Application of Filler Material
1) Clean small localized areas, such as voids and gaps.
2) Apply filler material and smooth.
3) Allow filler to dry and sand flush with panel or desired.
D. Adhesive Selection
1) Unless the airline obtains certification for new adhesive, only the adhesive system identified herein can be used for decorative replacement.
2) In many cases the adhesive is an inherent part of the decorative material. In such cases no additional adhesive is required.
E. Installation of decorative material with self adhesive backing 1) Self adhesive decorative is generally used with soft pliable covering materials up
to .010" thick. 2) Clean surface. 3) Cut film with scissors, knife or any other sharp blade as follows:
a.
Measure the application surface or refer to the applicable Bolder Mfg. Drawing for the decorative material size
b.
Add minimum of 1" to height and width dim.
c.
Select a self adhesive decorative application method most appropriate to each application from step (G) of this paragraph.
F. Installation of decorative material with contact cement 1) Clean surface to be bonded. 2) Apply a thin, even coat of adhesive with a spray gun, roller or brush to the surface
to be covered and the back side of the Decorative Material. 3) Avoid a heavy layer of Cement to prevent stringing and clumping. 4) Allow adhesive to dry for 15-25 minutes. 5) Apply covering material from one side maintaining a uniform direction, pressing
the decorative material firmly to get full contact and continue to the end of the decorative.
Caution: When applying the decorative material one section at a time avoid other areas of the decorative to make contact with the application surface as the contact will cause immediate adherence.
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757-200 LH RH CLASS DIVIDER(9)
