ALL  01 Page 401  Apr 15/7434-43-05
 WEATHER RADAR RECEIVER/TRANSMITTER MOUNT - REMOVAL/INSTALLATION
_______________________________________________________________
 1.  General
_______
 A.  On Passenger Airplanes; The receiver/transmitter mount is attached to the shelf assembly. To remove the mount, the mount must be electrically and mechanically disconnected from the shelf assembly. The mount is supplied by the same manufacturer as the R/T and is the interface between the R/T and other weather radar components and airplane wiring. The shelf is the interface between the R/T mount and the airplane forward equipment center (E5) rack installation.
 B.  On Freighter Airplanes; Two receiver/transmitter mounts are installed below the compartment floor in the nose cargo area. The mounts are supplied by the same manufacturer as the R/Ts and are the interface between the R/Ts and other weather radar components and airplane wiring. Access to the R/T mounts is gained by removing floor compartment panels in the nose cargo area.
 NOTE: Refer to 34-43-00 Maintenance Practices to clean weather radar
____
 R/T mount filter.

 2.  Equipment and Materials
_______________________
 A.  Bonding Meter (Ref 20-22-01)
 3.  Referenced Procedures
_____________________
 A.  20-11-15, Bonding Jumper and Ground Leads
 B.  24-22-0, Maintenance Practices (Apply Power)
 C.  34-43-02, Weather Radar Receiver/Transmitter - Removal/Installation
 4.  Remove the R/T Mount on Passenger Airplanes (Fig. 401)
___________________________________________
 A.  Open WEA RAD R/T No. 1 and 2 and WEA RAD IND No. 1 and 2 circuit breakers on overhead circuit breaker panel P7 and tag circuit breakers with Do-Not-Operate identifiers.
 B.  Remove R/T No. 1 and 2 from R/T mount (Ref 34-43-02).
 C.  Remove screws, lockwashers and gasket securing waveguide to waveguide switch. Retain hardware.
 D.  Disconnect electrical connector from waveguide switch.
 E.  Remove retaining screws and nuts securing electrical connectors to R/T mount. Retain hardware.
 F.  Remove electrical connectors from R/T mount.
 G.  Remove screws securing R/T mount to shelf assembly (Fig. 401).
 H.  Carefully remove R/T mount from shelf assembly.
 CAUTION: EXERCISE CARE TO PREVENT ACCIDENTAL DAMAGE TO WIRE BUNDLES
_______ OR COAX CABLES WHEN REMOVING R/T MOUNT FROM SHELF ASSEMBLY.
 5.  Remove the R/T Mounts on Freighter Airplanes (Fig. 401)
____________________________________________
 A.  Open these circuit breakers and attach DO-NOT-CLOSE tags:
 (1) On the overhead circuit breaker panel P7:
 (a)
WEA RDR R/T 1

 (b)
WEA RDR R/T 1

 B.  Remove the floor compartment panels in the nose cargo area to gain access to the receiver/transmitters.
 EFFECTIVITY
 
 ALL  11 Page 401  Apr 25/9334-43-13
SEE  A 
B  SWITCH FAN TEST R/T COOLING 
SEE  B  ASSEMBLY R/T MOUNT  SEE  B 
R/T MOUNT WAVEGUIDE 
GASKET LOCKWASHERS AND WAVEGUIDE SCREWS, 
TO ANTENNA WAVEGUIDE 
ASSEMBLY SHELF 
WITH BONDING WIRE FASTENER BUILDUP CENTER RACK FORWARD EQUIPMENT A COLLINS R/T MOUNT WIRE GROUND BOUNDING (SHOWN WITHOUT CONNECTORS) PANEL ASSEMBLY CABLES TO E5 DISCONNECT  NOT USED C 

Weather Radar R/T Mount - Removal/Installation
Figure 401 (Sheet 1)

EFFECTIVITY

PASSENGER AIRPLANES WITH COLLINS WXR-700X WEATHER 799 Page 402RADAR SYSTEM Apr 25/93
34-43-13
B68202
SEE D
R/T MOUNT
FORWARD EQUIPMENTCENTER RACK
SHELF ASSEMBLY
GROUND BONDING WIRE
FASTENER BUILDUP WITH BONDING WIRE CABLES TO E5 DISCONNECT PANEL ASSEMBLY (SHOWN WITHOUT CONNECTORS)
BENDIX R/T MOUNT
D
Weather Radar R/T Mount - Removal/Installation
Figure 401 (Sheet 2)

R/T COOLING FAN
TEST SWITCH
R/T MOUNT WAVEGUIDE
WAVEGUIDE SCREWS, LOCKWASHERS AND GASKET
WAVEGUIDE TO ANTAENNA
B68266
EFFECTIVITY

PASSENGER AIRPLANES WITH BENDIX RDR-4A WEATHER 799 Page 403RADAR SYSTEM Apr 25/93
34-43-13
TRANSMITTER RECEIVER/ NO. 2 
NO. 1 TRANSMITTER RECEIVER/ 
ESEE FLOOR BEAM AIRPLANE  E  SEE  F 
WAVEGUIDE FEEDER 
FEEDER WAVEGUIDE  R/T MOUNTS 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747飛機維護(hù)手冊AMM CHAPTER 34 - NAVIGATION 第34章導(dǎo)航4(17)