EFFECTIVITY
AF AF, AT, GN, MD, AND VM CONFIG 2 AF ALL AIRPLANES WITH AEB ATG A Page 501 AF 34-587 AND AEB 34-607 Apr 25/96
34-53-00
AF 3) TPR PASS lamp comes on AF 4) TPR PASS lamp goes of approximately 10 seconds after the AF TEST button is released. AF E. ATC 2 Operational Test AF (1) On the ATC control panel AF (a) Set the function selector to 2 AF (b) Set the ALT RPTG switch to OFF AF (c) Press TEST button and verify: AF 1) RPLY is shown on function display AF 2) FAIL light comes on for approximately 3 seconds AF 3) The display shows PASS. (See Note above.) AF (2) Do these steps for the ATC 2 transponder. AF (a) Check that R/T and ANT fault annunciators are black. If AF yellow, push the RESET button to turn them black. AF AF NOTE:____On some ATC, only ANT annunciator can be reset with the AF RESET button. If R/T annunciator is yellow, replace AF equipment. AF AF (b) Push the green REPLY light and verify AF 1) RPLY is shown on control panel display AF 2) Green REPLY light on the transponder is on all the time the AF button is pressed and stays on approximately 15 sec. after AF the button is released. AF AF NOTE:____The green replay light is ON as long as the AF transponder is replying to a ground station AF interrogation. So, it can be steady ON before or AF after a test sequence. AF AF 3. _________________________
System Test - ATC 1 and 2 AF A. General AF (1) The ATC system test is a complete system checkout of the ATC. AF (2) Two test procedures are described: AF (a) One for No. 1 ATC mode S AF (b) The other for No. 2 ATC mode A/C (ATCRBS) AF (3) The external IFR ATC 601 ramp test set is required to check No. 1 AF ATC. It will be used also for No. 2 ATC in the following system AF test. (See also step 1.B(2).) AF (4) No. 1 ATC transponder responds to signals from the antenna with the AF larger received signal strength. It is necessary to put the test AF antenna near the applicable ATC antenna to make sure that the test AF is done correctly (top or bottom antenna). AF B. Special Tools and Equipment AF (1) Ramp test set IFR 601. AF (2) Portable pressure equipment to simulate 0 to 40000 feet altitude AF (AMM 34-11-00/501). AF C. Referenced Procedures AF (1) AMM 34-11-00/501, Pitot Static System - Adjustment/Test Apply AF pressure AF (2) AMM 34-12-00/501, Central Air Data Computer System - Adjustment/Test
EFFECTIVITY AF AF, AT, GN, MD, AND VM CONFIG 2 AF ALL AIRPLANES WITH AEB ATG A Page 502 AF 34-587 AND AEB 34-607 Apr 25/96
34-53-00
AF (3) AMM 34-53-00/501, ATC Adjustment/Test. Operational test
AF (4) AMM 32-61-00/104, Landing Gear Indicating and Warning System -
AF Troubleshooting
AF D. Prepare for the System Test
AF (1) Supply electrical power (AMM 24-22-00/201).
AF (2) Make sure ATC 1 and ATC 2 C/Bs are closed on P7 panel.
AF WARNING: YOU MUST CAREFULLY FOLLOW THE STEPS IN THE GIVEN TASK TO_______
AF PREPARE THE SAFETY SENSITIVE SYSTEMS FOR THE AIR MODE. FAILURE
AF TO FOLLOW THE STEPS CORRECTLY CAN CAUSE THE AUTOMATIC OPERATION
AF OF THE AIRPLANE SYSTEMS. THIS CAN CAUSE INJURY TO PERSONS AND
AF DAMAGE TO EQUIPMENT.
AF
AF (3) Place airplane in simulated Flight mode (AMM 32-61-00/104).
AF
AF (4) Do the operational test of the ATC system.
AF (5) Prepare the test set for the ATC system test.
AF
AF CAUTION: DO NOT OPERATE THE ATC TEST SET WHEN ITS REMOTE TEST_______
AF ANTENNA IS LESS THAN 15 INCHES (38 CM) FROM THE
AF AIRPLANES'S ATC ANTENNA. DAMAGE TO THE TEST SET CAN
AF OCCUR.
AF
AF (a) Put the test set antenna in position towards the aircraft ATC 1
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747飛機維護手冊AMM CHAPTER 34 - NAVIGATION 第34章導航4(77)
