- repair the above wiring.
(2) If the wiring is correct:
- replace the EIU-2 (1KS2) (Ref. AMM TASK 73-25-34-000-040) and (Ref. AMM TASK 73-25-34-400-040).
F 『 EEFF : ALL E ∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 264
E E Feb 01/05 E
RE ECES
E F 『 E C F M E E E E 56 E E E (3) If the fault continues:
- replace the CONT-ZONE TEMPERATURE (8HK) (Ref. AMM TASK 21-63-34-000-001) and (Ref. AMM TASK 21-63-34-400-001).
(4) If the fault continues:
- replace the ECU (4000KS) (Ref. AMM TASK 73-21-60-000-001) and (Ref. AMM TASK 73-21-60-400-001).
B. Do the test given in Para. 3.A.
F 『 EEFF : ALL E ∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 265
E E Feb 01/05 ERE
ECES
F 『
E C F M E
E E
E 56 E
E E
TASK 73-25-00-810-893
Loss of Data on the ARINC Bus from the EIU to the FADEC on Engine 1
1. Possible Causes
_______________
- CONT-ZONE TEMPERATURE (8HK)
- EIU-1 (1KS1)
- ECU (4000KS) R - harness J3
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R ASM 732506 AMM 21-63-34-000-001 AMM 21-63-34-400-001 AMM 73-21-60-000-001 AMM 73-21-60-400-001 AMM 73-25-34-000-040 AMM 73-25-34-400-040 Removal of the Zone Controller (8HK)Installation of the Zone Controller (8HK)Removal of the Electronic Control Unit (ECU)Installation of the Electronic Control Unit (ECU)Removal of the Engine Interface Unit (EIU)Installation of the Engine Interface Unit (EIU)
3. Fault Confirmation__________________
A. Test
(1) Not applicable.
4. Fault Isolation_______________
A. Replace the CONT-ZONE TEMPERATURE (8HK) (Ref. AMM TASK 21-63-34-000-001) and (Ref. AMM TASK 21-63-34-400-001).
R (1) If the fault continues:
R - Do a check for open or short to ground of the harness J3 between
R the EIU (1KS1) and the ECU (4000KS) pins AB/5A, 5C to pins J3/22,
R 23 (Ref. ASM 732506):
R (a) If the wiring is not correct:
R - repair the above wiring.
R
R (b) If the wiring is correct:
- Replace the EIU-1 (1KS1) (Ref. AMM TASK 73-25-34-000-040) and
(Ref. AMM TASK 73-25-34-400-040). R
F 『
∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 266
EEFF : ALL E
E E Aug 01/05
E E
ECES E
F 『
E C F M E
E E
E 56 E
E E
R (c) If the fault continues:
- replace the ECU (4000KS) (Ref. AMM TASK 73-21-60-000-001) and (Ref. AMM TASK 73-21-60-400-001).
B. No additionnal maintenance action is required if the fault is not confirmed.
(1) Repeat the fault isolation procedure if the fault continues.
F 『 EEFF : ALL E ∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 267
E E Aug 01/05 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
TASK 73-25-00-810-894
Loss of Data on the ARINC Bus from the EIU to the FADEC on Engine 2
1. Possible Causes
_______________
- CONT-ZONE TEMPERATURE (8HK)
- EIU-2 (1KS2)
- ECU (4000KS) R - harness J3
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R ASM 732506 AMM 21-63-34-000-001 AMM 21-63-34-400-001 AMM 73-21-60-000-001 AMM 73-21-60-400-001 AMM 73-25-34-000-040 AMM 73-25-34-400-040 Removal of the Zone Controller (8HK)Installation of the Zone Controller (8HK)Removal of the Electronic Control Unit (ECU)Installation of the Electronic Control Unit (ECU)Removal of the Engine Interface Unit (EIU)Installation of the Engine Interface Unit (EIU)
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 發動機燃油和控制 2(56)
