-
if you do not do the usual servicing.

 -
if you replace a system component and the task does not operate the flight controls.

 (a)  
Supply hydraulic power with the demand pump (AMM 29-11-00/201).

 (b)  
Operate all the flight control surfaces through a minimum of four full cycles.

 (c)  
Remove the hydraulic power (AMM 29-11-00/201).

 (10)
 Turn the selector valve handle to the CLOSED position.

 S 843-016

 (11)
 Remove the pump handle from the hand pump socket.

 S 843-015
 (a)  Put the pump handle in the stowage clips.
 S 843-017
 (12) Remove the filler hose from the container of hydraulic fluid.
 (a)  
Drain the hose.

 (b)  
Put the hose in the stowage tube.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-12-01
 ALL  ú ú 01 Page 305 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 863-018
 (13)
 Remove the hydraulic power if it is not necessary
 (AMM 29-11-00/201).

 S 863-019

 (14)
 Remove the electrical power if it is not necessary
 (AMM 24-22-00/201).

 TASK 12-12-01-603-020
 3. Hydraulic Reservoir Servicing (Pressure Fill Procedure) (Fig. 301)
_______________________________________________________
 A. Standard Tools and Equipment
 (1)  Hydraulic Service Cart - This cart must supply a flow of BMS 3-11 fire-resistant hydraulic fluid.
 B. References
 (1)  
AMM 09-11-00/201, Towing Taxiing

 (2)  
AMM 12-15-09/301, Hydraulic Brake Accumulator

 (3)  
AMM 24-22-00/201, Manual Control

 (4)  
AMM 29-11-00/201, Main Hydraulic Supply System

 C. Access
 (1)  Location Zone
 137A Body Landing Gear Wheel Well, LH

 D. Procedure
 S 863-021
 (1)  
Supply electrical power (AMM 24-22-00/201).

 S 863-040

 (2)  
Make sure the airplane is in the correct configuration:

 (a)  
All the landing gear is down.

 (b)  
All the landing gear doors are closed.

 (c)  
The airplane steering is in neutral.

 (d)  
The spoilers are retracted.

 (e)  
Hydraulic power removed (AMM 29-11-00/201).

 NOTE: You can supply power to the hydraulic system
____ for servicing but the quantity can change when hydraulic system power is removed.
 (f)  Parking brake released with wheel chocks installed (AMM 10-11-01/201).
 NOTE: You can set the parking brake for servicing but
____ the reservoir quantity can change when the parking brake is released.
 S 863-023
 (3)  Make sure the ground lockpins for the landing gear are installed (AMM 09-11-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-12-01
 ALL  ú ú 01 Page 306 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 213-024
 (4)  When you do the servicing on the system No. 4 reservoir, do a check
 of the brake accumulator to make sure it has the correct precharge
 pressure (AMM 12-15-09/301).
 S 863-025
 (5)  Pressurize the hydraulic reservoir (AMM 29-11-00/201).
 NOTE:____ You can remove the hydraulic reservoir pressure for
 easier servicing.  But, the quantity can change when the
 reservoir does not have pressure.

 S 013-043
 (6)  Remove the pressure filler cap.
 S 493-065
 WARNING: DO NOT GET THE HYDRAULIC FLUID IN YOUR MOUTH OR EYES, OR ON
_______ YOUR SKIN. YOU CAN ABSORB POISONOUS MATERIALS FROM THE FLUID THROUGH YOUR SKIN. IF YOU GET THE FLUID IN YOUR EYES OR YOUR MOUTH, INTERNAL INJURY CAN OCCUR.
 CAUTION: TO PREVENT CONTAMINATION OF THE HYDRAULIC SYSTEM, USE CLEAN
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 SERVICING 1(37)