(2)  
A fast check of the servicing for all of the main landing gear

 (3)  
A task to measure the fluid level in the shock strut without the removal of the fluid (pressure/extension check).

 B.  There is no easy procedure to do a check of the fluid level in the shock strut. The volume of the fluid changes when you pressurize the shock strut with nitrogen or dry air. You must do the full servicing procedure to accurately fill the shock strut.
 C.  On the pressure gages for the shock struts, the vendor bends the indicator during calibration. A gage with a bent indicator is usually satisfactory.
 TASK 12-15-03-613-017
 2.  Wing Landing Gear Shock Strut Servicing_______________________________________
 A.  General
 (1)  
This task has the instructions to fill and pressurize a shock strut of the wing landing gear. This procedure has the same data that is on the nameplate and servicing placard on the shock strut.

 (2)  
Each shock strut contains approximately 21.0 gallons of hydraulic fluid. When the shock strut is full of fluid, you will pressurize it with nitrogen or dry air.

 (3)  
If only small quantities of fluid are necessary, you can use fluid without lubricant to fill the shock strut. If large quantities are necessary, add lubricant to the shock strut. As an alternative, you can use a fluid which has an added lubricant.

 B.  Special Tools and Equipment
 (1)  
3MIT65B00163-1 - Landing Gear Struts Service Manifold Assembly

 (2)  
F70200-14 - Strut Inflation Tool

 C.  Standard Tools and Equipment
 (1)  
Clean, nitrogen or dry air source - 2000 psi with pressure gages

 (2)  
Container with graduations - 90-ounce minimum capacity

 D.  Consumable Materials
 (1)  D00155 Lubrizol 1395 - Shock Strut Fluid Extreme Pressure Additive
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-03
 ALL  ú ú 01 Page 301 ú Feb 10/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 E.
F.
G.
A
747-400 MAINTENANCE MANUAL
 (2) D00509 Fluid - Hydraulic, Petroleum Base, MIL-H-6083 (alternate)
 NOTE: Unless you use only a small amount of fluid, approximately
____ 1.0 percent of the total, you must mix MIL-H-6083 in the correct proportion with Lubrizol 1395 before you fill the shock strut. You can use this fluid with MIL-H-6083 and use it as an alternative for MIL-H-5606.
 (3) D00070 Oil - Hydraulic, Petroleum Base, MIL-H-5606 (alternate)
 NOTE: Unless you use only a small amount of fluid, approximately
____ 1.0 percent of the total, you must mix MIL-H-5606 in the correct proportion with Lubrizol 1395 before you fill the shock strut. The MIL-H-5606 is recommended fluid over the MIL-H-6083 fluid. MIL-H-5606 and MIL-H-6083 fluids can be intermixed.
 (4) D00467 Fluid - Fully Formulated Hydraulic, BMS 3-32 (Recommended)
 Type I - Royco SSF, Shell SSF and Castrolaero 35 (These fluids
 contain the mixture of MIL-H-6083 and Lubrizol 1395)
 Type II - Royco LGF, Shell LGF and Castrolaero 40 (These fluids are the recommended fluid for servicing and contain the mixture of MIL-H-5606 and Lubrizol 1395)
References
 (1)
AMM 09-11-00/201, Towing

 (2)
AMM 32-00-30/201, Landing Gear Door Locks

 (3)
AIPC 32-11-01 Fig. 5Access

 (1)  
Location Zone 735 Wing Landing Gear, LH 745 Wing Landing Gear, RH

Procedure (Fig. 301)
 S 863-018
 (1) Make sure the airplane is not on jacks.
 S 493-025
 WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (2) Install the ground locks in all landing gear (AMM 09-11-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-03
 ALL  ú ú 01 Page 302 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 SERVICING 1(61)