22-10-00
 ALL  ú ú 06 Page 536 ú Feb 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 745-228
 (2)  When the test is completed, look for PASS or FAIL> adjacent to <FLAP XDUCER.
 NOTE: If a PASS indication shows, no failures occurred during the
____
 test.

 (a)  If FAIL> shows: 1) Push the LSK that is adjacent to FAIL> to see the GROUND TEST MSG pages for the failure. 2) Push the NEXT PAGE key until you find all the GROUND TEST MSG pages. 3) Make a list of all CMCS messages, CMCS message numbers, and ATA numbers that show on the GROUND TEST MSG pages.
 4)  Go to the CMCS Message Index of the Fault Isolation Manual (FIM) to find the corrective action for each CMCS message.
 G.  Put the Airplane in Its Usual Condition
 S 865-441
 (1)
Remove hydraulic power if it is not necessary (AMM 29-11-00/201).

 S 865-229

 (2)  
Remove the electrical power if it is not necessary
 (AMM 24-22-00/201).

 TASK 22-10-00-745-230
 16. Ground Test - Stabilizer Trim
_____________________________
 A.  General
 (1)  This test is for a check of the stabilizer trim. It makes sure that the stabilizer position is correctly sent to the FCC by the flap control unit. During this test, the stabilizer moves in the two directions. The stabilizer also moves in the nose-up direction and the final position is shown.
 B.  References
 (1)  
AMM 22-11-01/401, Flight Control Computer

 (2)  
AMM 24-22-00/201, Manual Control

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 01 Page 537 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (3)  
AMM 27-51-51/401, Flap Control Unit

 (4)  
AMM 29-11-00/201, Main Hydraulic Supply System

 (5)  
AMM 34-61-02/401, Control Display Unit

 (6)  
AMM 45-10-00/501, Central Maintenance Computer System

 C. Access
 (1)  Location Zones
 221 Control Cabin, LH
 222 Control Cabin, RH

 D. Preconditions
 S 865-458
 (1)  These conditions are necessary for this task:
 (a)  
Electrical Power On (AMM 24-22-00/201).

 (b)  
Central Maintenance Computer (CMC), serviceable (AMM 45-10-00/501).

 (c)  
Hydraulic Pressure Supplied (AMM 29-11-00/201).

 (d)  
Control Display Unit (CDU), serviceable (AMM 34-61-02/401).

 (e)  
Pilot's Overhead Maintenance Panel (P461), installed.

 (f)  
Flight Control Computer (FCC), serviceable (AMM 22-11-01/401).

 (g)  
Flap Control Unit (FCU), serviceable (AMM 27-51-51/401).

 E. Prepare for the Test
 S 865-231
 (1)  Supply electrical power (AMM 24-22-00/201).
 S 865-232
 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF ALL CONTROL
_______ SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. AILERONS, RUDDERS, ELEVATORS, FLAPS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (2)  Supply the hydraulic pressure to the hydraulic systems NO. 1, 2, 3 and 4 (AMM 29-11-00/201).
 NOTE: The hydraulic system NO. 4 is optional.
____
 S 865-233
 (3)  
Make sure the FLT CONTROL HYD POWER TAIL 1, 2, 3 and 4 switches are in the NORM position. These switches are on the Pilots' Overhead Maintenance Panel (P461).

 S 865-234

 (4)  
Make sure the FLT CONTROL HYD POWER WING 1, 2, 3 and 4 switches are in the NORM position. These switches are on the Pilots' Overhead Maintenance Panel (P461).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 01 Page 538 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機(jī)維護(hù)手冊 空調(diào) AUTO FLIGHT(51)