76-11-00
 ALL  ú ú C03 Page 520 ú Jul 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 215-165-C00
 (6)  If a start control cable or cables have been replaced, do the next steps.
 (a)  AIRPLANES WITHOUT THROTTLE CONTROL CABLE TURNBUCKLES IN THE
 FUSELAGE;
 AIRPLANES PRE-SB 76-1023;
 Adjust the cable tension to approximately 125 pounds (56.8
 kilograms) with the turnbuckles found in the forward cargo
 compartment and the wing leading edge.

 NOTE: Use a tensiometer to measure the cable tension.
____
 (b)  AIRPLANES WITH THROTTLE CONTROL CABLE TURNBUCKLES IN THE
 FUSELAGE;
 AIRPLANES POST SB 76-1023;
 Adjust the cable tension to approximately 125 pounds (56.8
 kilograms) with the turnbuckles found in the forward cargo
 compartment.

 NOTE: Use a tensiometer to measure the cable tension.
____
 (c)  
Move the start lever 25 times between the CUTOFF and IDLE
 positions.

 (d)  
Place the start lever in the CUTOFF detent.

 S 835-166-C00
 (7)  
Adjust the cable tension to the value shown in Table 501 for the applicable ambient temperature.

 S 835-167-C00

 (8)  
Increase the tension in the ESS1B/ESS2B cable for the reasons that follow:

 (a)  A 6.0 pound force (+2.0/-2.0 pounds) [2.72 kilogram force (+0.9/-0.9 kilograms)] is required at the start lever knob to move the start lever down from the detent face (Fig. 506).

 (9)  
Install the locking clips on the turnbuckles.

 S 435-168-C00
 S 415-169-C00
 CAUTION: MAKE SURE THAT THE VISIBLE PARTS OF THE CONTROL CABLES AND THE
_______ QUADRANTS IN THE WING LEADING EDGE AREA ARE NOT MOIST BEFORE YOU INSTALL THE ACCESS PANEL 6301 OR 6401. MOISTURE COULD FREEZE DURING THE FLIGHT AND PREVENT CORRECT SYSTEM OPERATION.
 (10)
 Install the access panel No. 6301 or No. 6401 (AMM 12-31-71/201).

 (11)
 Install the ceiling panels in the forward cargo compartment.

 S 415-170-C00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 76-11-00
 ALL  ú ú C02 Page 521 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 845-171-C00
 (12) Do the procedure: Put the Airplane Back to Its Usual Condition.
 H. Put the Airplane Back to Its Usual Condition
 S 095-172-C00
 WARNING:_______BE CAREFUL WHEN YOU WORK NEAR THE LEADING EDGE FLAPS. LEADING EDGE FLAPS MOVE VERY QUICKLY. INJURY CAN OCCUR.
 (1)  
Remove the locks on the leading edge of the flap (AMM 27-81-00/201).

 S 445-173-C00

 (2)  
Do the activation procedure for the thrust reverser system
 (AMM 78-31-00/201).

 TASK 76-11-00-705-060-C00
 4.  System Test - Engine Control System___________________________________
 A. General
 (1)  This task has these system tests:
 (a)  
A friction test of the start control system.

 (b)  
A friction test of the thrust control system.

 (c)  
A friction test of the reverese thrust control system.

 B. Equipment
 (1)  Scale - Spring, 0-30 pound capacity (commercially available)
 C. References
 (1)  
AMM 71-11-02/201, Fan Cowl Panels

 (2)  
AMM 78-31-00/201, Thrust Reverser System

 D. Access
 (1)  Location Zones
 101/102 Control Cabin, Left and Right
 502/602 Fan Cowl - Left

 E. Procedure
 S 735-178-C00
 (1)  Do the steps that follow to do a friction test of the start control system:
 NOTE: Measure all of the lever loads at the knob centerline,
____ perpendicular to a line that extends through the lever pivot and the knob center line.
 (a)  With the spring scale, measure the force necessary to move the start lever in either direction between the detents CUTOFF and IDLE. 1) The operational force must be 4.0 to 8.0 pounds (1.8 to 3.6
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 發動機控制 ENGINE CONTROLS(14)